Enhancement of natural convection heat transfer for cooling of electronic power chips
Authors:
- Amjed Al-KhateebAAAmjed Al-Khateeb
- Mohammed KhashanMKMohammed Khashan
- Mustafa KhashanMKMustafa Khashan
- Ali MutaibAMAli Mutaib
- 1 January 2021
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2404 (1) , 080001
Abstract
The present work interest in the cooling of electrical power chips, because such elements were prone to fail as a result of thermal load. A numerical analysis was performed aiming to study and investigate of improvement natural convection heat transfer by using two types of fins “cylindrical and twisted tapes fin” to maximize the cooling process and augmentation the heat dissipation rate of electronic circuits, Computational Fluid Dynamic “CFD” technique based on finite control volume method was adopted in form of ANSYS-FLUENT 19.1 program, the modeling process was carried out using SOLIDWORK program to design and build up the geometry. Since the geometry has curves and sharp edges unstructured mesh was applied with tetrahedron element for a better and accurate result. Mesh dependency was applied to check if the solution results are affected by the number of elements. The results found, the temperature difference increase with fin length increase and when twisted-tapes fins are used the temperature will be decreased to 268.27°C as compared with cylindrical fins that give 295.14°C, so using twisted tape fins will improve the heat transfer by 9% and minimizing generated temperature and thermal stress. the less material consumption with twisted-tapes fin design is cost-effective.Keywords
This publication has 11 references indexed in Scilit:
- Experimental and numerical investigation of natural convection heat transfer of W-type fin arraysInternational Journal of Heat and Mass Transfer, 2020
- Experimental investigation of the effects of horizontally oriented vertical sinusoidal wavy fins on heat transfer performance in case of natural convectionInternational Journal of Heat and Mass Transfer, 2019
- Numerical investigation on effects of using segmented and helical tube fins on thermal performance and efficiency of a shell and tube heat exchangerApplied Thermal Engineering, 2018
- Numerical investigation on heat transfer enhancement of heat sink using perforated pin fins with inline and staggered arrangementApplied Thermal Engineering, 2017
- Computational heat transfer analysis and combined ANN–GA optimization of hollow cylindrical pin fin on a vertical base plateSādhanā, 2015
- Comparison of different cooling systems using compact modelScientific Journals of Rzeszów University of Technology Series Electrotechnics, 2015
- Thermal analysis of convective fin with temperature-dependent thermal conductivity and heat generationCase Studies in Thermal Engineering, 2014
- Natural convection from rectangular interrupted finsInternational Journal of Thermal Sciences, 2014
- Numerical simulation of heat transfer and temperature distribution in a printed circuit board enclosure model for different geometries and Reynolds numbers2014
- Enhancement of natural convection heat transfer from a fin by triangular perforation of bases parallel and toward its tipApplied Mathematics and Mechanics, 2008