Research on the performance improvement of a two-shaft gas turbine with a variable area nozzle power turbine
Authors:
Open Access
- 1 January 2020
- journal article
- research article
- Published by National Library of Serbia in Thermal Science
- Vol. 24 (6 Part A) , 3721-3733
Abstract
Both an increase in atmospheric temperature and a decrease in atmospheric pressure can lead to the degradation of the maximum allowable power output (MAPO) or the thermal efficiency of a gas turbine. In order to reduce these adverse effects, this paper provides a simulated study on the improvement of the MAPO and the variations of the thermal efficiency due to the fuel flow and variable area nozzle control under different atmospheric conditions. Simulation results indicate that the MAPO increases with the power turbine nozzle area, while the thermal efficiency shows a parabola trend. With the same increment of the power turbine nozzle area, the improvement of the MAPO goes up as the atmospheric temperature rises and the decrease of thermal efficiency is alleviated. Analyses show that the slow degradation of the compressor isentropic efficiency is a key factor that enables the MAPO to increase significantly and the thermal efficiency to remain almost constant.Keywords
This publication has 19 references indexed in Scilit:
- Development and application of a thermodynamic-cycle performance analysis method of a three-shaft gas turbineEnergy, 2016
- An applicable method for gas turbine efficiency improvement. Case study: Montazar Ghaem power plant, IranJournal of Natural Gas Science and Engineering, 2016
- Microturbogas cogeneration systems for distributed generation: Effects of ambient temperature on global performance and components’ behaviorApplied Energy, 2014
- Gas turbine performance at varying ambient temperatureApplied Thermal Engineering, 2011
- A review of inlet air-cooling technologies for enhancing the performance of combustion turbines in Saudi ArabiaApplied Thermal Engineering, 2010
- Variable geometry gas turbines for improving the part-load performance of marine combined cycles – Gas turbine performanceEnergy, 2010
- Feasibility Study of an Intercooled-Cycle Marine Gas TurbineJournal of Engineering for Gas Turbines and Power, 2008
- Inlet Fogging of Gas Turbine Engines: Climatic Analysis of Gas Turbine Evaporative Cooling Potential of International LocationsJournal of Engineering for Gas Turbines and Power, 2006
- Inlet Air Cooling Methods for Gas Turbine Based Power PlantsJournal of Engineering for Gas Turbines and Power, 2005
- Analytical solutions and typical characteristics of part-load performances of single shaft gas turbine and its cogenerationEnergy Conversion and Management, 2002