Reinforcing Efficiency of Recycled Carbon Fiber PLA Filament Suitable for Additive Manufacturing
Authors:
- Loredana TammaroLTLoredana Tammaro
- Alfonso MartoneAlfonso Martone
- Barbara PalmieriBPBarbara Palmieri
- Carmela BorrielloCBCarmela Borriello
- Sabrina PortofinoSabrina Portofino
- Pierpaolo IovanePIPierpaolo Iovane
- Fabrizia CilentoFCFabrizia Cilento
- Michele GiordanoMichele Giordano
- Sergio GalvagnoSGSergio Galvagno
Open Access
Abstract
The use of 3D printing technology for manufacturing new products based on sustainable materials enables one to take advantage of secondary raw materials derived from recycling. This work investigates the structural performances of 3D printing composite filaments based on polylactic acid (PLA), as a matrix, reinforced by recycled carbon fiber (rCF). Carbon fibers were recovered from industrial scraps by a patented thermal process and used to produce thermoplastic composite filaments for additive manufacturing without any additional treatment and additives. The influence of the recovered carbon fiber (rCF) content on the thermal properties, mechanical properties and microstructure of the composites was studied in the range of 3–20 wt%. The recorded TGA curves exhibited a one-stage weight loss within the temperature range 290–380 °C for all samples and the residual rCF content was in good agreement with the theoretical fiber loading. The Young modulus of the extruded filaments strongly increased below a critical content (5 wt%), while at higher content the improvement was reduced. An increase in the storage modulus of 54% compared to neat PLA 3D printed sample resulted in a printed specimen with a higher rCF content. SEM images highlighted a strong rCF prevailing alignment in the direction of the extrusion flow, creating almost unidirectional reinforcement inside the filament. These findings suggest that homogeneous composite filaments reinforced with well-dispersed recycled CF without additional chemical modification and additives are suitable materials for additive manufacturing. The effect of rCF topological distribution within the material on the mechanical performances has been discussed, highlighting that the isolated fibers could efficiently transfer loads with respect to the percolated 3D network and have been correlated with the microstructure.Keywords
Funding Information
- Ministry of Industry and Made in Italy (F/310328/01-05/X56)
This publication has 39 references indexed in Scilit:
- Investigation on Stress Relaxation of Discontinuous Recycled Carbon Fiber CompositesJournal of Materials Engineering and Performance, 2023
- 3D printing of polylactic acid: recent advances and opportunitiesThe International Journal of Advanced Manufacturing Technology, 2023
- A review on carbon fiber-reinforced hierarchical composites: mechanical performance, manufacturing process, structural applications and allied challengesCarbon Letters, 2022
- Carbon fibers derived from commodity polymers: A reviewCarbon, 2022
- A review on the recycling of waste carbon fibre/glass fibre-reinforced composites: fibre recovery, properties and life-cycle analysisSN Applied Sciences, 2020
- Fabrication of continuous carbon, glass and Kevlar fibre reinforced polymer composites using additive manufacturingAdditive Manufacturing, 2017
- Carbon Fiber Reinforced Thermoset Composite with Near 100% RecyclabilityAdvanced Functional Materials, 2016
- The status, challenges, and future of additive manufacturing in engineeringComputer-Aided Design, 2015
- Thermal decomposition of biodegradable polyesters—II. Poly(lactic acid)Polymer Degradation and Stability, 1996
- Micromechanics of short-fiber compositesComposites Science and Technology, 1992