Analysis of a Radial Groove Gas Face Seal
Author:
- 1 January 1992
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 35 (1) , 11-20
Abstract
An outside-pressurized, bi-directional, gas face seal is analyzed here. This seal face is made up of a hydrodynamic section, consisting of alternate regions of land and groove, and a hydrostatic dam. The groove region, based on its optimum width, can have either parallel or radial side boundaries, depending on the cost of machining and tooling. The compressible Reynolds equation is solved over a radial groove hydrodynamic section by both finite difference and finite element methods. The former algorithm is seen to be about two to three times faster than the latter, but there is room for improvement in both. Next, a finite element solution is obtained over a corresponding parallel groove geometry. Both geometries yield approximately the same results, other parameters remaining equal. Hence, for design optimization purposes, a radial groove approximation may be justified for a parallel groove design in order to use the faster and easier finite difference algorithm. The flow over the hydrostatic section is modeled as 1-D viscous flow. Thus, the pressure distribution over the entire seal interface and the seal leakage are determined for a given film thickness. Finally, the separating force is obtained as a function of film thickness for a given design, allowing the operating point to be predicted.Keywords
This publication has 23 references indexed in Scilit:
- An Evaluation of Finite Difference and Finite Element Methods for the Solution of the Reynolds EquationA S L E Transactions, 1986
- A Pressure-Parameter Method for Finite-Element Solutions of Reynolds' EquationA S L E Transactions, 1985
- A study of iterative solution techniques for elliptic partial differential equations with particular reference to the reynolds equationComputer Methods in Applied Mechanics and Engineering, 1975
- Analytical Investigation of the Spiral Groove Face SealJournal of Lubrication Technology, 1973
- Finite Element Solution of the Steady-State Compressible Lubrication ProblemJournal of Lubrication Technology, 1970
- Finite-Element Solution of the Incompressible Lubrication ProblemJournal of Lubrication Technology, 1969
- Review of Numerical Methods in Gas Bearing Film AnalysisJournal of Lubrication Technology, 1968
- Behavior of Hydrostatic and Hydrodynamic Noncontacting Face SealsJournal of Lubrication Technology, 1968
- Numerical Analysis of the Gas-Lubricated Spiral-Groove Thrust Bearing-CompressorJournal of Lubrication Technology, 1967
- Analysis and Design of Spiral-Groove BearingsJournal of Lubrication Technology, 1967