A study of polymer melt flow instabilities in extrusion

Authors:
Publisher website
Google Scholar
Abstract
An experimental study is carried out to elucidate the melt fracture mechanism. For the study, the electrical outputs of the melt pressure transducers, mounted on the wall of a circular tube, are recorded on a Sanborn recording system. It has been observed from this study that the wall pressures start to fluctuate prior to the inception of visible melt fracture. The frequency and amplitude of the excursion signals are increased as the shear rate is increased up to and beyond the critical value. This behavior has been observed for three polymer samples tested: polystyrene, high density polyethylene, and low density polyethylene. The fluctuations of wall pressures are interpreted as due to an irregular flow of polymer melts at the tube wall. It is further investigated to find the effects of the die entry angle of a capillary, and capillary length‐to‐diameter ratio on the critical shear rate. A correlation between exit pressure and shear stress has been found for polystyrene and low density polyethylene. It is found that at and above the critical stress, the exist pressure increases abruptly. This is interpreted to be a sudden change in the elastic properties of the materials above melt fracture since Han et al have shown that the exist pressure is a measure of the elastic properties.

This publication has 18 references indexed in Scilit: