Dynamic mechanical and thermogravimetric analysis of PTFE blended tailor-made textile woven basalt–vinyl ester composites
- 30 December 2016
- journal article
- research article
- Published by SAGE Publications in Journal of Industrial Textiles
- Vol. 47 (6) , 1226-1240
Abstract
In this work, the authors prepared basalt–vinyl ester tailor-made green composites with uncoated and polytetrafluroethylene coated basalt woven fabric. These composites were subjected to dynamic composites-made mechanical analysis and thermo gravimetric analysis. Results revealed that a significant improvement of 18%, 14% and 13% was observed for storage and loss modulus and damping properties of polytetrafluroethylene-coated composite at low temperature region. The thermo gravimetric analysis results indicated a three-stage degradation for the polytetrafluroethylene-filled composites. Based on the acceptability from the literature, the tribo-test was performed only on the polytetrafluroethylene-coated composite for the selected PV limit of 400 MPa-mm/s (10 KN and 50 mm/s) in a flat-on-flat configuration. It was found that the influence of polytetrafluroethylene filler on the static and dynamic coefficient of friction and specific wear rate of the composite was more pronounced at dry wear test condition and it was found as 0.22, 0.12, and 4.87484 E-09, respectively. However, the results of improved storage and loss modulus and damping manifested negative correlation with the friction characteristics in the glassy region. Further, the SEM-coupled EDX spectral analysis was performed to understand the formation of transfer layer in counter surface. This polytetrafluroethylene blended composite is to be considered as an alternative to the bearing materials in offshore application.Keywords
This publication has 29 references indexed in Scilit:
- Investigation of the effect of surface modifications on the mechanical properties of basalt fibre reinforced polymer compositesComposites Part B: Engineering, 2012
- A correlation between the tribological and mechanical properties of short carbon fibers reinforced PEEK materials with different fiber orientationsTribology International, 2010
- Hot wear properties of ceramic and basalt fiber reinforced hybrid friction materialsTribology International, 2007
- Effects of various fillers on the sliding wear of polymer compositesComposites Science and Technology, 2005
- Chemical composition and charge stability of highly crystalline pulsed-laser-deposited polytetrafluoroethylene films on metal substratesApplied Physics A, 2001
- Tribological properties of micron silicon carbide filled poly(ether ether ketone)Journal of Applied Polymer Science, 1999
- Role of reinforcing ceramic particles in the wear behaviour of polymer-based model compositesWear, 1995
- Microscopy study of the frictional wear of polytetrafluoroethyleneWear, 1986
- The effect of carbon aspect ratio on the friction and wear of PTFEWear, 1977
- Polymer-based bearing materialsTribology, 1972