Numerical simulations of lock-exchange compositional gravity current
- 10 September 2009
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 635, 361-388
Abstract
Compositional gravity current flows produced by the instantaneous release of a finite-volume, heavier lock fluid in a rectangular horizontal plane channel are investigated using large eddy simulation. The first part of the paper focuses on the evolution of Boussinesq lock-exchange gravity currents with a large initial volume of the release during the slumping phase in which the front of the gravity current propagates with constant speed. High-resolution simulations are conducted for Grashof numbers $\sqrt {Gr}$ = 3150 (LGR simulation) and $\sqrt {Gr}$ = 126000 (HGR simulation). The Grashof number is defined with the channel depth h and the buoyancy velocity ub = $\sqrt {g'h}$ (g′ is the reduced gravity). In the HGR simulation the flow is turbulent in the regions behind the two fronts. Compared to the LGR simulation, the interfacial billows lose their coherence much more rapidly (over less than 2.5h behind the front), which results in a much faster decay of the large-scale content and turbulence intensity in the trailing regions of the flow. A slightly tilted, stably stratified interface layer develops away from the two fronts. The concentration profiles across this layer can be approximated by a hyperbolic tangent function. In the HGR simulation the energy budget shows that for t > 18h/ub the flow reaches a regime in which the total dissipation rate and the rates of change of the total potential and kinetic energies are constant in time. The second part of the paper focuses on the study of the transition of Boussinesq gravity currents with a small initial volume of the release to the buoyancy–inertia self-similar phase. When the existence of the back wall is communicated to the front, the front speed starts to decrease, and the current transitions to the buoyancy–inertia phase. Three high-resolution simulations are performed at Grashof numbers between $\sqrt {Gr}$ = 3 × 104 and $\sqrt {Gr}$ = 9 × 104. Additionally, a calculation at a much higher Grashof number ( $\sqrt {Gr}$ = 106) is performed to understand the behaviour of a bottom-propagating current closer to the inviscid limit. The three-dimensional simulations correctly predict a front speed decrease proportional to t−α (the time t is measured from the release time) over the buoyancy–inertia phase, with the constant α approaching the theoretical value of 1/3 as the current approaches the inviscid limit. At Grashof numbers for which $\sqrt {Gr}$ > 3 × 104, the intensity of the turbulence in the near-wall region behind the front is large enough to induce the formation of a region containing streaks of low and high streamwise velocities. The streaks are present well into the buoyancy–inertia phase before the speed of the front decays below values at which the streaks can be sustained. The formation of the velocity streaks induces a streaky distribution of the bed friction velocity in the region immediately behind the front. This distribution becomes finer as the Grashof number increases. For simulations in which the only difference was the value of the Grashof number ( $\sqrt {Gr}$ = 4.7 × 104 versus $\sqrt {Gr}$ = 106), analysis of the non-dimensional bed friction velocity distributions shows that the capacity of the gravity current to entrain sediment from the bed increases with the Grashof number. Past the later stages of the transition to the buoyancy–inertia phase, the temporal variations of the potential energy, the kinetic energy and the integral of the total dissipation rate are logarithmic.
Keywords
This publication has 30 references indexed in Scilit:
- Effects of channel geometry on buoyancy-driven mixingPhysics of Fluids, 2008
- On the front velocity of gravity currentsJournal of Fluid Mechanics, 2007
- Analysis of the flow and mass transfer processes for the incompressible flow past an open cavity with a laminar and a fully turbulent incoming boundary layerJournal of Fluid Mechanics, 2006
- Gravity currents produced by lock exchangeJournal of Fluid Mechanics, 2004
- Analysis and direct numerical simulation of the flow at a gravity-current head. Part 2. The lobe-and-cleft instabilityJournal of Fluid Mechanics, 2000
- On the propagation of internal boresJournal of Fluid Mechanics, 1997
- Modeling of one-dimensional turbidity currents with a dissipative-Galerkin finite element methodJournal of Hydraulic Research, 1995
- A proposed modification of the Germano subgrid-scale closure methodPhysics of Fluids A: Fluid Dynamics, 1992
- The propagation of two-dimensional and axisymmetric viscous gravity currents over a rigid horizontal surfaceJournal of Fluid Mechanics, 1982
- Effects of the lower boundary on the head of a gravity currentJournal of Fluid Mechanics, 1972