“Effect of tungsten carbide (WC) on electrochemical corrosion behavior, hardness, and microstructure of CrFeCoNi high entropy alloy”
Open Access
- 13 May 2022
- journal article
- research article
- Published by Springer Nature in Journal of Engineering and Applied Science
- Vol. 69 (1) , 1-17
Abstract
High-entropy alloy HEA (CrFeCoNi) was reinforced with variety of weight percentages of 5:20 wt.% WC particles. The alloy samples were mechanically prepared in a ball roll mill for 25 h by 10:1 ball to powder ratio at 180 rpm. Then WC was mixed with the prepared alloys in a high-speed ball mill for 1 h by 350 rpm under a controlled atmosphere. The mixed samples were compacted by a uniaxial press under 700 MPa and then sintered at 1200 °C for 90 min under air atmosphere. The corrosion behavior of the tested samples in 3.5 wt.% NaCl solution was investigated using electrochemical polarization measurements. The microstructure of the sintered samples with high relative density showed three phases, which were FCC matrix, W-rich carbide, and Cr-rich carbide and homogeneously distributed all over the alloy matrix. The hardness of the (CrFeCoNi)1-X (WC)X HEAs was increased gradually with the increasing of WC content from about 336.41 HV up to 632.48 HV at room temperature. The results indicated that the addition of WC improves the corrosion resistance. Especially, the 20 wt.% of WC addition remarkably enhanced the comprehensive corrosion resistance and easy passivation of (CrFeCoNi)1-X(WC)X HEAs. Also, the wear rate of 0 wt.% WC HEA is (1.70E-04) which is approximately 4.5 times higher than the wear rate of 20 wt.% WC HEA (3.81E-05); this means that wear resistance is significantly improved with the increase of WC content.Keywords
This publication has 39 references indexed in Scilit:
- Physico-mechanical and tribological properties of Cu/h-BN nanocomposites synthesized by PM routeJournal of Alloys and Compounds, 2015
- Laser gas assisted treatment of AISI H12 tool steel and corrosion propertiesOptics and Lasers in Engineering, 2014
- Alloy Design Strategies and Future Trends in High-Entropy AlloysJOM, 2013
- Microstructure and Corrosion Properties of AlCoCrFeNi High Entropy Alloy Coatings Deposited on AISI 1045 Steel by the Electrospark ProcessMetallurgical and Materials Transactions A, 2012
- Nanocrystalline CoCrFeNiCuAl high-entropy solid solution synthesized by mechanical alloyingJournal of Alloys and Compounds, 2009
- On the elemental effect of AlCoCrCuFeNi high-entropy alloy systemMaterials Letters, 2007
- Validation of corrosion rates measured by the Tafel extrapolation methodCorrosion Science, 2005
- Microstructure and electrochemical properties of high entropy alloys—a comparison with type-304 stainless steelCorrosion Science, 2005
- Microstructural development in equiatomic multicomponent alloysMaterials Science and Engineering: A, 2004
- Modification of Archard’s equation by taking account of elastic/pseudoelastic properties of materialsWear, 2001