Wideband variable gain amplifier with noise cancellation
Authors:
- 20 January 2011
- journal article
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 47 (2) , 116-118
Abstract
A 1–5 GHz noise-cancelling variable gain amplifier is presented in 0.18 µm CMOS technology that achieves a low noise figure (NF) below 4.8 dB over an 11 dB gain range. Its NF is as low as 3.2 dB for the gain range of 5.5 to 11 dB, while its input return loss is better than 13 dB over the entire gain range of −5 to 11 dB. The measured input-referred two-tone third-order intercept point (IIP3) at 2.4 GHz is better than 0 and −4.5 dBm at minimum and maximum gain, respectively. The circuit occupies an area of only 0.067 mm2 and consumes less than 19 mW of power from a 1.8 V supply.Keywords
This publication has 4 references indexed in Scilit:
- A 2.5mW inductorless wideband VGA with dual feedback DC-offset correction in 90nm CMOS technology2008
- A Highly Linear Broadband CMOS LNA Employing Noise and Distortion CancellationIEEE Journal of Solid-State Circuits, 2008
- Design Techniques of CMOS Ultra-Wide-Band Amplifiers for Multistandard CommunicationsIEEE Transactions on Circuits and Systems II: Express Briefs, 2008
- A low-voltage and variable-gain distributed amplifier for 3.1-10.6 GHz UWB systemsIEEE Microwave and Wireless Components Letters, 2006