Effect of B4C Amount on Microstructural and Mechanical Properties of Cu/h-BN/B4C Metal Matrix Composites Fabricated via Spark Plasma Sintering
Open Access
Abstract
Copper (Cu) is widely used in electrical, electronic, and tribological systems owing to its excellent electrical and thermal conductivity. However, its relatively low hardness and poor wear resistance limit its use in demanding engineering applications. In this study, Cu-based hybrid metal matrix composites (MMCs) reinforced with hexagonal boron nitride (h-BN) and boron carbide (B4C) were fabricated via spark plasma sintering (SPS) to improve their mechanical and tribological performance. The h-BN content was fixed at 1 wt.% to ensure solid lubrication, while the B4C content was varied (0.25, 0.5, 0.75, and 1 wt.%) to examine its influence on the microstructural, mechanical, electrical, and wear properties of the composites. Microstructural analyses confirmed a homogeneous distribution of h-BN and B4C particles in the Cu matrix at low and moderate reinforcement levels, whereas excessive B4C resulted in partial agglomeration and reduced densification. All composites achieved relative densities above 95%, demonstrating the high densification efficiency of the SPS process. Hardness increased markedly with B4C addition due to dispersion strengthening and grain refinement, while electrical conductivity decreased slightly because of the insulating nature of the reinforcements. Tribological tests showed that the composite containing 0.75 wt.% B4C exhibited the best performance, with the lowest wear rate and stable friction behavior. Overall, the results indicate that co-reinforcing Cu with h-BN and B4C through SPS is a promising strategy for developing multifunctional materials suitable for electrical contact and sliding applications.Keywords
This publication has 58 references indexed in Scilit:
- Effect of Nitride Addition on Microstructure, Hardness, and Wear Resistance of Additively Manufactured Stainless SteelJournal of Materials Engineering and Performance, 2025
- Researches for higher electrical conductivity copper‐based materialscMat, 2024
- A review on the preparation and application of BN composite coatingsCeramics International, 2022
- Effect of Processing Route on the Mechanical and Tribological Behaviour of AA8011 Hybrid CompositesJournal of The Institution of Engineers (India): Series D, 2022
- Corrosion and Mechanical Properties of Novel AA2024 Matrix Hybrid Nanocomposites Reinforced with B4C and SiC ParticlesSilicon, 2022
- Effect of the usage of Er,Cr:YSGG laser with and without different remineralization agents on the enamel erosion of primary teethLasers in Medical Science, 2020
- Studies on High Temperature Wear and Friction Behaviour of AA6061/B4C/hBN Hybrid CompositesMetals and Materials International, 2020
- Microstructure and mechanical properties of Cu‐B 4 C and CuAl‐B 4 C composites produced by hot pressingRare Metals, 2019
- Effects of SPS parameters on the densification and mechanical properties of TiB2-SiC compositeCeramics International, 2019
- Thermal properties of multilayer graphene and hBN reinforced copper matrix compositesJournal of Thermal Analysis and Calorimetry, 2019