Joining of Zirconia Ceramic to Stainless Steel and to Itself Using Ag 57 Cu 38 Ti 5 Filler Metal
Authors:
- 1 August 1995
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 78 (8) , 2157-2160
Abstract
The brazing of ZrO 2 ceramic to 1Cr18Ni9Ti stainless steel and to itself was performed using Ag 57 Cu 38 Ti 5 filler metal under a vacuum of 7 × 10 ‐3 Pa. The effects of interlayer copper on the ceramic to stainless steel joint strength, and the brazing temperature (1073 to 1323 K) and holding time (0 to 60 min) on ceramic to ceramic joint strength were investigated. The joint strength was evaluated by shear testing. An interfacial reaction layer between the ceramic and the filler metal was found, and the reaction products were δ‐TiO and γ‐AgTi 3 . The joint strength of ZrO 2 ceramic to stainless steel was improved by using a layer of copper of a suitable thickness. The brazing temperature and holding time had a strong influence on the joint strength of ceramic to ceramic, and the joint strength was mainly controlled by reaction layer thickness and the properties of the reaction products. The maximum shear strength was obtained for brazing at 1123 K for 30 min and an interfacial reaction layer thickness of ∼4.4 μm.Keywords
This publication has 11 references indexed in Scilit:
- Effects of brazing temperature on the fracture toughness of Al2O3AgCu0.5Ti jointsScripta Metallurgica et Materialia, 1992
- Interlayer design for joining pressureless sintered sialon ceramic and 40Cr steel brazing with Ag57Cu38Ti5 filler metalJournal of Materials Science, 1992
- The wetting, reaction and bonding of silicon nitride by Cu-Ti alloysJournal of Materials Science, 1991
- Contribution to the study of reactive wetting in the CuTi/Al2O3 systemJournal of Materials Science, 1991
- Residual Stress in a Soft‐Buffer‐Inserted Metal/Ceramic JointJournal of the American Ceramic Society, 1990
- Effect of residual stress on the strength of alumina-steel joint with Al-Si interlayerJournal of Materials Science, 1990
- Residual stresses and cracking in brittle solids bonded with a thin ductile layerActa Metallurgica, 1988
- Effect of Thickness on Direct Bonding of Silicon Nitride to SteelJournal of the American Ceramic Society, 1985
- Effect of Interlayers in Ceramic‐Metal Joints with Thermal Expansion MismatchesJournal of the American Ceramic Society, 1984
- Metal‐Ceramic Interactions: II, Metal‐Oxide Interfacial Reactions at Elevated TemperaturesJournal of the American Ceramic Society, 1953