In situmonitoring of the sintering behavior of microcomposite particles using a laser scanning micrometer
Authors:
- 1 August 1998
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 13 (8) , 2202-2205
Abstract
The densification behavior of silica-coated alumina particles was investigated during sintering using a laser scanning micrometer. Traditional dilatometric techniques require contact between a push-rod and the sample under study and thus place the sample under stress during the test. However, the utilization of a noncontact laser micrometer to measure dimensional changes during sintering enabled the densification behavior to be very accurately characterized under a stress-free condition. Thus higher temperature experiments, where densification rates are particularly temperature sensitive and the samples are especially soft, can be reliably investigated without the disturbing influence of an external force. The present paper describes an application of the technique to evaluate the densification behavior from 900–1300 °C of silica-coated alumina microcomposite particles used for the fabrication of mullite.Keywords
This publication has 6 references indexed in Scilit:
- Mullite Formation by Endothermic Reaction of α‐Alumina/Silica Microcomposite ParticlesJournal of the American Ceramic Society, 1996
- Effect of Seeding on Phase Development, Densification Behavior, and Microstmcture Evolution in Mullite Fabricated from Microcomposite ParticlesJournal of the American Ceramic Society, 1995
- Sintering and viscosity of commercial glass powdersJournal of Materials Science Letters, 1995
- Constant heating rate analysis of simultaneous sintering mechanisms in aluminaJournal of Materials Science, 1992
- Fabrication of Mullite and Mullite‐Matrix Composites by Transient Viscous Sintering of Composite PowdersJournal of the American Ceramic Society, 1991
- Initial Sintering with Constant Rates of HeatingJournal of the American Ceramic Society, 1970