Microporous membranes of isotactic poly(4‐methyl‐1‐pentene) from a melt‐extrusion process. I. Effects of resin variables and extrusion conditions
Authors:
- 26 December 2001
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 83 (10) , 2095-2113
Abstract
A study utilizing isotactic poly(4‐methyl‐1‐pentene) (PMP) was undertaken to investigate a three‐stage process (melt‐extrusion/annealing/uniaxial‐stretching) (MEAUS) employed to produce microporous films. The results of this study will be reported in the course of two articles. In this first part, three PMP resins were melt‐extruded into tubular films (blowup ratio; BUR = 1), where the resins each differ in weight‐average molecular weight (Mw). Specific attention was focused upon the morphological and crystal orientation results as a function of the melt‐relaxation times as influenced by the resin characteristics and the processing parameters. The results of a number of melt‐extrusion conditions are presented. A stacked lamellar morphology was obtained in each case; however, the type of stacked lamellar morphology, planar or twisted, and the orientation state was found to depend upon both the resin characteristics, specifically Mw, and the melt‐extrusion conditions. Atomic force microscopy and wide‐angle X‐ray scattering (WAXS) were the main techniques utilized to study the melt‐extruded films, while oscillatory shear measurements, in conjunction with a Carreau–Yasuda analysis, aided in differentiating the melt‐flow behavior of the three resins. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 2095–2113, 2002Keywords
This publication has 22 references indexed in Scilit:
- Melt-spun asymmetric poly(4-methyl-1-pentene) hollow fibre membranesJournal of Membrane Science, 1997
- Influence of molecular weight distribution on the melt extrusion of high density polyethylene (HDPE): Effects of melt relaxation behavior on morphology and orientation in HDPE extruded tubular filmsJournal of Rheology, 1996
- Structural characterization of Celgard® microporous membrane precursors: Melt‐extruded polyethylene filmsJournal of Applied Polymer Science, 1994
- Shear‐rate‐dependence modeling of polymer melt viscosityPolymer Engineering & Science, 1992
- Some correlations involving the shear viscosity of polystyrene meltsRheologica Acta, 1989
- Light scattering from crystalline superstructure in tubular‐extruded polybutene‐1 filmsJournal of Polymer Science: Polymer Physics Edition, 1977
- Thermodynamic properties of poly-4-methyl-pentene-1Polymer, 1967
- The X‐ray diffraction, birefringence, and infrared dichroism of stretched polyethylene. II. Generalized uniaxial crystal orientationJournal of Polymer Science, 1958
- The X‐ray diffraction, birefringence, and infrared dichroism of stretched polyethylene. III. Biaxial orientationJournal of Polymer Science, 1958
- The x‐ray diffraction, birefringence, and infrared dichroism of stretched polyethyleneJournal of Polymer Science, 1956