Variable-dose (1017–1020 cm−3) phosphorus ion implantation into 4H–SiC
Authors:
- 15 November 2000
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 88 (10) , 5630-5634
Abstract
Multiple-energy box profile elevated-temperature (700 °C) phosphorus ion implantations were performed into 4H–SiC in the doping range of The implanted material was annealed at 1500, 1600, or 1650 °C with an AIN encapsulant to prevent degradation of the SiC surface. Within this temperature range the sheet resistance does not change significantly for a given dose. The percentage of electrical activation of the P donors initially decreased with increasing implant dose for P-implant concentration up to and then increased again at higher doses. For P implant, a carrier concentration of was measured at room temperature. In the P doping concentration range substitutional activation greater than 85% was measured. Despite performing the implants at 700 °C, a significant amount of as-implanted damage was observed in the Rutherford backscattering (RBS) spectrum, even for range P implantations. The RBS yield after annealing is near the virgin level for P concentrations up to but above this concentration the RBS yield is above the virgin level, indicating a significant amount of residual lattice damage in the crystal.
Keywords
This publication has 26 references indexed in Scilit:
- Material and n–p junction characteristics of As- and Sb-implanted SiCDiamond and Related Materials, 2000
- Hot-Implantation of Phosphorus Ions into 4H-SiCMaterials Science Forum, 2000
- Ionization Energies and Electron Mobilities in Phosphorus- and Nitrogen-Implanted 4H-Silicon CarbideMaterials Science Forum, 2000
- Relationship between Donor Activation and Defect Annealing in 6H-SiC Hot-Implanted with Phosphorus IonsMaterials Science Forum, 2000
- Donor ion-implantation doping into SiCJournal of Electronic Materials, 1999
- Characterization of phosphorus implantation in 4H-SiCJournal of Electronic Materials, 1999
- Silicon Carbide High Frequency DevicesMaterials Science Forum, 1998
- Hot-Implantation of Phosphorus Ions into 6H-SiCMaterials Science Forum, 1998
- Elevated temperature nitrogen implants in 6H-SiCJournal of Electronic Materials, 1996
- The effects of N+ dose in implantation into 6h-sic epilayersJournal of Electronic Materials, 1995