Influence of binding interface between active and support layers in composite PDMS membranes on permeation performance
Authors:
- 27 February 2007
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 104 (4) , 2468-2477
Abstract
Effect of the binding interfaces of composite polydimethylsiloxane (PDMS) membranes on their pervaporation performance was studied. The membranes were made up of PDMS as active skin layer and polysulfone (PSF) or polyamide (PA) as supporting layer. PDMS‐PSF membrane was numbered 1, and PDMS‐PA membrane numbered 2. The pervaporation experiments were carried out by using the composite membranes and dilute ethanol–water mixture. The experimental measurements for the permeation performance under various operating conditions (e.g., feed concentration and temperature) showed that the specific permeation rate of membrane 2 was over membrane 1 by seven times at least. A resistance‐in‐series model was applied to formularize the transport of the permeants. Influence of the binding interfaces between the active skin layer and support layers in these membranes on pervaporation performance was analyzed. The cross section morphology of the membranes and chemical element distribution along membrane thickness were examined by using SEM and EDS. It was found that, although the PDMS intrusion layer into PSF near the interface was only about 2 μm, it gave significant effect on the permeation performance. It implied that the resistance produced by the intrusion layer into PSF was apparently larger than that of PDMS intruding PA and over intrinsic PDMS resistance. These should be probably attributed to structures and formation of the binding interfaces. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 2468–2477, 2007Keywords
This publication has 28 references indexed in Scilit:
- Pervaporation of dilute alcoholic mixtures using PDMS membraneChemical Engineering Science, 2005
- Composite PDMS membrane with high flux for the separation of organics from water by pervaporationJournal of Membrane Science, 2004
- Pervaporation properties of a three-layer structure composite membraneJournal of Applied Polymer Science, 2000
- Influence of ceramic support on pervaporation characteristics of IPA/water mixtures using PDMS/ceramic composite membraneJournal of Membrane Science, 1999
- Intrusion of PDMS top layers in porous supportsJournal of Membrane Science, 1999
- Pervaporation performance of oligosilylstyrene-polydimethylsiloxane membrane for separation of organics from waterJournal of Membrane Science, 1997
- Pervaporation of ethanol-water mixtures through polydimethylsiloxane-polystyrene interpenetrating polymer network supported membranesJournal of Membrane Science, 1996
- Considerations on interface resistances in the process of permeation of dense membranesJournal of Membrane Science, 1993
- Pervaporation of ethanol/water mixtures using novel hydrophobic membranes containing polydimethylsiloxane☆Journal of Membrane Science, 1992
- Diffusion in Gases and Porous Media1980