Passive charge modulation for a wireless pressure sensor
Authors:
- D.O. KazmerDKD.O. Kazmer
- R.X. GaoRGR.X. Gao
- R.W. JacksonRJR.W. Jackson
- 16 January 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 6 (1) , 47-54
Abstract
A wireless pressure sensor is described for use in a high-pressure manufacturing process with three major subsystems: energy conversion by a stack of piezoelectric disks, energy measurement and control by a threshold modulator, and ultrasonic signal transmission by a piezoelectric transmitter. The second system, the threshold modulator, is the focus of this paper. The charge, proportional to pressure, on a capacitive element is measured and controlled through the use of a two-transistor modulator. Standard NPN and PNP transistors are used to passively control the flow of charge between a piezoelectric stack and an ultrasonic transmitter. The basis for the design is discussed, from which a simulation is developed and compared to a bench top prototype. The results of this comparison indicate the appropriateness of the assumptions used to produce an analytical model of the design and the limiting conditions under which the modulator will effectively measure charge. Finally, the prototype device is optimized with respect to sensitivity, gain, and operating range for use in real-time process monitoring and control.Keywords
This publication has 7 references indexed in Scilit:
- Design of ultrasonic transmitters with defined frequency characteristics for wireless pressure sensing in injection moldingIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2005
- Energy Extraction for a Self-Energized Pressure SensorIEEE Sensors Journal, 2004
- Self-energized wireless pressure sensor using energy extraction from injection mold pressure differential2003
- Evaluation of a Piezoelectric Energy Extraction Device for Cavity Pressure Sensing in Injection Molding2003
- Threshold Energy Switching and Its Application to Wireless Sensing in High Energy Manufacturing Processes2002
- Various equivalent circuits for thickness mode piezoelectric transducersElectronics and Communications in Japan (Part II: Electronics), 1996
- The design of efficient broad-band piezoelectric transducersIEEE Transactions on Sonics and Ultrasonics, 1978