Technology for processing balanced feed charge based on copper-, lead-containing products
Authors:
- Satbayev UniversitySUSatbayev University
- N.K. DosmukhamedovNDN.K. Dosmukhamedov
- E.E. ZholdasbayEZE.E. Zholdasbay
- O.A. Baikonurov Zhezkazgan UniversityOUO.A. Baikonurov Zhezkazgan University
- A.A. ArgynAAA.A. Argyn
- Yu.B. IchevaYIYu.B. Icheva
- M.B. KurmanseitovMKM.B. Kurmanseitov
- 13 February 2025
- journal article
- Published by Institute of Metallurgy and Ore Benefication (Publications) in Kompleksnoe Ispolzovanie Mineralnogo Syra = Complex Use of Mineral Resources
- Vol. 336 (1) , 96-104
Abstract
The study examined the behavior of copper, lead, zinc, and arsenic during the reductive-oxidative processing of a balanced charge under scaled-up technology conditions. The optimal parameters for ensuring high comprehensive recovery of metals into targeted products were identified: lead into rough lead, copper into matte, and zinc into slag. The feasibility of conducting reductive-oxidative smelting of a balanced charge was demonstrated. Optimal technology parameters were established: gas blowing time with natural gas – 20 minutes; with oxygen – 20 minutes; methane consumption – 1.7 times higher than that from the stoichiometric requirement for the reduction of lead compounds; oxygen consumption – 1.4 times higher than that from the stoichiometric requirement for the oxidation of zinc and iron sulfides; temperature – 1523 K. High rates of comprehensive selective recovery of metals into targeted products were achieved: lead into rough lead – 97.6%; copper into matte – 98.6%; zinc into slag – 56.8%, into matte – 1.7%, into dust and gases – 41.5%; arsenic and antimony into dust – up to 97.4% and 90%, respectively. A balanced charge processing technology has been developed for processing substandard intermediates of copper and lead production.Keywords
This publication has 20 references indexed in Scilit:
- Mineralogical characteristics of copper smelting slag affecting the synchronous flotation enrichment of copper and arsenicJournal of Environmental Chemical Engineering, 2022
- Formation mechanism of arsenic-containing dust in the flue gas cleaning process of flash copper pyrometallurgy: A quantitative identification of arsenic speciationChemical Engineering Journal, 2021
- Dissociation mechanism of particulate matter containing arsenic and lead in smelting flue gas by pyriteJournal of Cleaner Production, 2020
- Integrated experimental study and thermodynamic modelling of the distribution of arsenic between phases in the Cu-Fe-O-S-Si systemThe Journal of Chemical Thermodynamics, 2019
- Distribution and Behavior of Arsenic During the Reducing-Matting Smelting ProcessJOM, 2017
- Separation of Arsenic from the Antimony-Bearing Dust through Selective Oxidation Using CuOMetallurgical and Materials Transactions B, 2017
- Efficient Removal of Arsenic and Antimony During Blast Furnace Smelting of Lead-Containing MaterialsJOM, 2016
- Computational Thermodynamics Modeling of Minor Element Distributions During Copper Flash ConvertingMetallurgical and Materials Transactions B, 2012
- Thermodynamic Modeling of Arsenic in Copper Smelting ProcessesMetallurgical and Materials Transactions B, 2010
- Simulation of the removal of arsenic during the roasting of copper concentrateMetallurgical and Materials Transactions B, 1999