Temperature distribution in powder beds during 3D printing
Authors:
- 3 August 2010
- journal article
- Published by Emerald Publishing in Rapid Prototyping Journal
- Vol. 16 (5) , 328-336
Abstract
Purpose – This purpose of this paper is to report about the temperature distribution in metal and ceramic powder beds during 3D printing. The differing powders are thoroughly characterized in terms of thermal conductivity, thermal diffusivity, emissivity spectra and density. Design/methodology/approach – The temperature distribution was measured in a 3D printing appliance (Prometal R1) with the help of thin thermocouples (0.25?mm diameter) and thermographic imaging. Temperatures at the powder bed surface as well as at differing powder bed depths were determined. The thermal conductivity, thermal diffusivity and emissivity spectra of the powders were measured as well. Numerical simulation was used to verify the measured temperatures. Findings – The ceramic powder heated up and cooled down more quickly. This finding corresponds well with numerical simulations based on measured values for thermal conductivity and thermal diffusivity as well as emissivity spectra. An observed color change at the metal powder has only little effect on emissivity in the relevant wavelength region. Research limitations/implications – It was found that thermocouple-based temperature measurements at the powder bed surface are difficult and these results should be considered with caution. Practical implications – The results give practitioners valuable information about the transient temperature evolution for two widely used but differing powder systems (metal, ceramic). The paramount importance of powder bed porosity for thermal conductivity was verified. Already small differences in thermal conductivity, thermal diffusivity and hence volumetric heat capacity lead to marked differences in the transient temperature evolution. Originality/value – The paper combines several techniques such as temperature measurements, spectral emissivity measurements, measurements of thermal conductivity and diffusivity and density measurements. The obtained results are put into a numerical model to check the obtained temperature data and the other measured values for consistency. This approach illustrates that determinations of surface temperatures of the powder beds are difficult.Keywords
This publication has 13 references indexed in Scilit:
- Osteoconduction and osteoinduction of low-temperature 3D printed bioceramic implantsBiomaterials, 2008
- The Berlin emissivity database (BED)Planetary and Space Science, 2007
- Finite element analysis of temperature distribution in single metallic powder layer during metal laser sinteringInternational Journal of Machine Tools and Manufacture, 2007
- Direct Printing of Bioceramic Implants with Spatially Localized Angiogenic FactorsAdvanced Materials, 2007
- Temperature measurements during selective laser sintering of titanium powderInternational Journal of Machine Tools and Manufacture, 2004
- 3D FE simulation for temperature evolution in the selective laser sintering processInternational Journal of Machine Tools and Manufacture, 2004
- Mechanisms of selective laser sintering and heat transfer in Ti powderRapid Prototyping Journal, 2003
- Total hemispherical emissivity of oxidized Inconel 718 in the temperature range 300–1000°CExperimental Thermal and Fluid Science, 2000
- Study of radiative heat transfer in vacuum-powder insulation by infrared spectroscopyJournal of Engineering Physics and Thermophysics, 1975
- Calculation of Temperature Distributions in Glass Plates Undergoing Heat‐TreatmentJournal of the American Ceramic Society, 1958