Corrosion Induced Degradation of Pt/C Model Electrodes Measured with Electrochemical Quartz Crystal Microbalance
Authors:
- BjörN WickmanBWBjörN Wickman
- Henrik GrönBeckHGHenrik GrönBeck
- Per HanarpPHPer Hanarp
Open Access
- 1 January 2010
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 157 (4) , B592-B598
Abstract
Degradation of fuel cell model electrodes during accelerated aging was studied using electrochemical quartz crystal microbalance with dissipation monitoring. The model electrodes, consisting of Pt particles (5 nm) on planar carbon and Pt-only and carbon-only films, were prepared by thermal evaporation onto uncoated quartz crystal sensors. The characterization of electrode composition and morphology was performed by X-ray photoelectron spectroscopy, Raman spectroscopy, transmission electron microscopy, and atomic force microscopy. The experiments were conducted in a flow cell with 0.5 M at room temperature and up to by repeated cycling between 0.02 and (where RHE is reversible hydrogen electrode) at . During cyclic corrosion, the Pt-only sample loses mass equivalent to 0.6% of a monolayer per cycle in a process that is not temperature-dependent. The experiments with the Pt particle layer on a carbon electrode show a mass loss that is almost 2 times larger than the Pt-only sample and exhibits an Arrhenius type of temperature dependence. The results suggest that the presence of Pt catalyzes carbon corrosion with an apparent activation energy of 0.33 eV. In all measurements, the carbon-only sample loses much less mass than the other samples.Keywords
This publication has 52 references indexed in Scilit:
- Model study on the stability of carbon support materials under polymer electrolyte fuel cell cathode operation conditionsJournal of Power Sources, 2009
- The maximum potential a PEM fuel cell cathode experiences due to the formation of air/fuel boundary at the anodeJournal of Solid State Electrochemistry, 2009
- Measurement of oxygen reduction activities via the rotating disc electrode method: From Pt model surfaces to carbon-supported high surface area catalystsElectrochimica Acta, 2008
- Multiscale Model of Carbon Corrosion in a PEFC: Coupling with Electrocatalysis and Impact on Performance DegradationJournal of the Electrochemical Society, 2008
- The Effect of Transient Potential Exposure on the Electrochemical Oxidation of Carbon Black in Low-Temperature Fuel CellsJournal of the Electrochemical Society, 2008
- Characterization of Carbon Corrosion-Induced Structural Damage of PEM Fuel Cell Cathode Electrodes Caused by Local Fuel StarvationJournal of the Electrochemical Society, 2008
- An investigation into factors affecting the stability of carbons and carbon supported platinum and platinum/cobalt alloy catalysts during 1.2V potentiostatic hold regimes at a range of temperaturesJournal of Power Sources, 2007
- Effects of operating potential and temperature on degradation of electrocatalyst layer for PEFCsElectrochimica Acta, 2007
- Size effects of platinum particles on the electro-oxidation of methanol in an aqueous solution of HClO4Electrochemistry Communications, 2000
- The Corrosion of Carbon Black in Phosphoric AcidJournal of the Electrochemical Society, 1978