Measurement of uniaxial anisotropy in Rogers RO3010 substrate material
- 1 November 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
A new technique using a dual mode ¿RA resonator¿ to measure uniaxial anisotropy in planar substrates is applied to Rogers RO3010 material. When this technique was previously applied to FR-4, an unexpected result (a horizontal dielectric constant less than the vertical dielectric constant) was obtained. It is hypothesized that the unexpected result is due to the fact that FR-4 is inhomogeneous. For example the glass fiber weave embedded in the FR-4 epoxy is not uniformly distributed. To test this hypothesis, similar measurements are performed on Rogers RO3010 material, which is strongly anisotropic, perfectly homogeneous, and is known from independent measurements to have a horizontal dielectric constant greater than the vertical. Several modifications to the original RA resonator that increase the frequency range over which useful measurements can be acquired are described and demonstrated.Keywords
This publication has 2 references indexed in Scilit:
- Measurement of Planar Substrate Uniaxial AnisotropyIEEE Transactions on Microwave Theory and Techniques, 2009
- A Proposed Uniaxial Anisotropic Dielectric Measurement Technique2009