Abstract
Carbon steel has been exposed in CO2 saturated brine at 70C at 1 bar total pressure and with varied amounts of sodium bicarbonate and ferrous ions. Electrochemical polarisation experiments were used for the study of the corrosion rate and response of the anodic and cathodic reactions to changes in the environment. The measurements were carried out after a couple of minutes' exposures in order to investigate the influence of pH and concentration of ferrous ions under conditions with the minimum of corrosion films and after some hours or days in order to identify the changes of the electrode kinetics caused by corrosion films. A pH shift from 4 to 6.2, obtained by addition of sodium bicarbonate to solutions with low concentrations of ferrous ions, reduced the corrosion rate with about 50%. This applied both for very short and some days' exposures. A reduced rate of the cathodic reactions by increased pH was responsible for this. Ferrous bicarbonate in concentrations well below the solubility limit of FeCO3 had no ion specific effect on the carbon dioxide corrosion of carbon steel. Its influence is predictable from the pH shift. Much larger effects of the bicarbonate concentration occurred with 50 ppm ferrous ions present, and are attributed to formation of more protective films containing FeCO3. The combined effect of film formation and that of pH alone led to a 20 times' reduction of the corrosion rate when pH was raised from 3.8 to 6.2 in experiments with 50 ppm Fe2+.