Comparison between wire-mesh sensor and ultra-fast X-ray tomograph for an air–water flow in a vertical pipe
Authors:
- H.-M. PrasserHPH.-M. Prasser
- M. MisawaMMM. Misawa
Top Cited Papers
- 1 April 2005
- journal article
- Published by Elsevier in Flow Measurement and Instrumentation
- Vol. 16 (2-3) , 73-83
Abstract
No abstract availableKeywords
Funding Information
- Ministry of Education, Culture, Sports, Science and Technology
This publication has 11 references indexed in Scilit:
- Simulation of Multi-dimensional Heterogeneous and Intermittent Two-Phase Flow by Using an Extended Two-Fluid ModelJournal of Nuclear Science and Technology, 2003
- Bubble size measurement using wire-mesh sensorsFlow Measurement and Instrumentation, 2001
- Fast Wire-Mesh Sensor for Two-Phase Flow Visualisation with 10 000 Frames per SecondChemie Ingenieur Technik, 2001
- Application of Fast X-ray CT Scanner to Visualization of Bubbles in Fluidized Bed.JOURNAL OF CHEMICAL ENGINEERING OF JAPAN, 2000
- A new electrode-mesh tomograph for gas–liquid flowsFlow Measurement and Instrumentation, 1998
- Tomographisches Messen der relativen Phasenanteile in zweiphasigen Strömungen fluider PhasenChemie Ingenieur Technik, 1996
- Application of cadmium telluride detector to high speed X-ray CT scannerNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 1996
- A γ-ray tomographic scanner for imaging voidage distribution in two-phase flow systemsFlow Measurement and Instrumentation, 1995
- Void fraction estimation within rod bundles based on three-fluid model and comparison with x-ray CT void dataNuclear Engineering and Design, 1990
- Experimental study on void fraction in a simulated BWR fuel assembly (evaluation of cross-sectional averaged void fraction)Nuclear Engineering and Design, 1989