Assessing the Corrosion Resistance of Painted Steel by AC Impedance and Electrochemical Noise Techniques
Authors:
- C-T. ChenCCC-T. Chen
- 1 August 1991
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 47 (8) , 598-611
Abstract
Four organic coatings of commercial grade (polyurethane, epoxy-polyamide, medium-quality and low-cost alkyds) with an expected range of corrosion protective properties were applied to steel substrates and immersed for up to 4,300 h in 0.6 M NaCl solution. These painted electrodes were assessed by AC impedance in the frequency range 60 kHz to 0.1/0.01 Hz and also by a statistical analysis of the voltage and current noise transients generated under freely corroding conditions. Good corrosion-resistant coatings were associated with stable paint-film AC resistance (Ff) values and derived noise resistance (Rn) values of the order of 108 to 1010 Ω · cm2. Associated capacitances were also stable in the range 10-10 F/cm2. Relatively poor corrosion protection occurred when the Rf value decreased below ~ 105 Ω · cm2. Associated capacitance values in and above the μF/cm2 range suggested increased exposed electrode areas under delaminating paint and/or formation of corrosion pits. For significantly degraded paints, the Rn values were somewhat higher than the equivalent Rf values because of charge-transfer and diffusion effects, which are not separated in the noise data. Immersion performance trends were consistent with results obtained from samples exposed for 12 months to an industrial atmosphere, suggesting that immersion testing may provide information relevant to atmospheric exposure conditions. In this respect, further work is necessary.Keywords
This publication has 6 references indexed in Scilit:
- Electrochemical testing to assess corrosion protective coatingsProgress in Organic Coatings, 1987
- ELECTROCHEMICAL NOISE MEASUREMENTS FOR THE STUDY OF LOCALIZED CORROSION AND PASSIVITY BREAKDOWN1983
- The Nature of the Passive Film on Iron: II . A‐C Impedance StudiesJournal of the Electrochemical Society, 1982
- Application of impedance measurements to study performance of painted metals in aggressive solutionsJournal of Electroanalytical Chemistry and Interfacial Electrochemistry, 1981
- Electrical measurements in the study of immersed paint coatings on metal. I. Comparison between capacitance and gravimetric methods of estimating water‐uptakeJournal of Chemical Technology & Biotechnology, 1954
- Electrolytic Resistance in Evaluating Protective Merit of Coatings on MetalsIndustrial & Engineering Chemistry, 1948