Fully Integrated Capacitive DC–DC Converter With All-Digital Ripple Mitigation Technique
Authors:
- 13 May 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 48 (8) , 1910-1920
Abstract
This paper presents an adaptive all-digital ripple mitigation technique for fully integrated capacitive dc-dc converters. Ripple control is achieved using a two-pronged approach where coarse ripple control is achieved by varying the size of the bucket capacitance, and fine control is achieved by charge/discharge time modulation of the bucket capacitors used to transfer the charge between the input and output, both of which are completely digital techniques. A dual-loop control was used to achieve regulation and ripple control. The primary single-bound hysteretic control loop achieves voltage regulation and the secondary loop is responsible for ripple control. The dual-loop control modulates the charge/discharge pulse width in a hysteretic variable-frequency environment using a simple digital pulse width modulator. The fully integrated converter was implemented in IBM's 130-nm CMOS process. Ripple reduces from 98 to 30 mV, when ripple control secondary loop is enabled for a load of 0.3 V and 4 mA without significantly impacting the converter's core efficiency. Measurement results show constant ripple, independent of output voltage. The converter achieves a maximum efficiency of 70% for Vin= 1.3 V and Vout= 0.5 V and a maximum power density of 24.5 mW/mm2, including the areas for the decoupling capacitor. The maximum power density increases to 68 mW/mm2 if the decoupling capacitor is assumed to be already present as part of the digital design.Keywords
This publication has 11 references indexed in Scilit:
- Design Techniques for Fully Integrated Switched-Capacitor DC-DC ConvertersIEEE Journal of Solid-State Circuits, 2011
- Fully-Integrated On-Chip DC-DC Converter With a 450X Output RangeIEEE Journal of Solid-State Circuits, 2011
- A Fully-Integrated Switched-Capacitor Step-Down DC-DC Converter With Digital Capacitance Modulation in 45 nm CMOSIEEE Journal of Solid-State Circuits, 2010
- An Ultra-Low-Energy Multi-Standard JPEG Co-Processor in 65 nm CMOS With Sub/Near Threshold Supply VoltageIEEE Journal of Solid-State Circuits, 2010
- A 32 kb 10T Sub-Threshold SRAM Array With Bit-Interleaving and Differential Read Scheme in 90 nm CMOSIEEE Journal of Solid-State Circuits, 2009
- A High-Efficiency DC–DC Converter Using 2 nH Integrated InductorsIEEE Journal of Solid-State Circuits, 2008
- An SC Voltage Doubler with Pseudo-Continuous Output Regulation Using a Three-Stage Switchable OpampIEEE Journal of Solid-State Circuits, 2007
- Ultra-Dynamic Voltage Scaling (UDVS) Using Sub-Threshold Operation and Local Voltage DitheringIEEE Journal of Solid-State Circuits, 2005
- Area-efficient linear regulator with ultra-fast load regulationIEEE Journal of Solid-State Circuits, 2005
- A dynamic voltage scaled microprocessor systemIEEE Journal of Solid-State Circuits, 2000