Curing efficiency of various types of light‐curing units
Authors:
- 10 February 2004
- journal article
- research article
- Published by Wiley in European Journal of Oral Sciences
- Vol. 112 (1) , 89-94
Abstract
This study compared monomer conversion (DC), the per cent linear polymerization shrinkage (%LS), the wall‐to‐wall contraction pattern (per cent of peripheral opening, %DM, and maximal marginal gap, MG) and depth of cure (DOC), of a hybrid resin composite (Spectrum TPH) exposed to different types of light‐curing units and exposure modes (Virtuoso‐PAC, Elipar TriLight‐QTH, and FreeLight‐LED). The QTH and LED units were used in two curing modes: the exponential ramp and the continuous output modes. Monomer conversion was investigated by micro Multiple Internal Reflection (MIR)‐Fourier‐transform infrared (FTIR) spectroscopy and %LS was measured by the deflective disc method. The wall‐to‐wall contraction method used a cylindrical cavity model in extracted human teeth. The per cent debonded margins relative to the cavity periphery (%DM) and the width of maximum gap (MG) was evaluated. The DOC was determined using Vickers microhardness measurements (200 g load, 20 s) at the top surface (H0), at 2 mm (H2) and at 4 mm (H4) depths, and the results expressed as H2/H0 and H4/H0 ratios. Significantly lower %DC and %LS values were provided by PAC and LED units. No differences were found in %DM among the curing units and PAC exhibited the highest MG. No significant differences were noted among light‐curing groups in terms of H2/H0 microhardness values. The QTH, operated in exponential mode, resulted in the highest H4/H0 value. The exponential mode of the QTH demonstrated superior performance for the total of the characteristics evaluated.Keywords
This publication has 29 references indexed in Scilit:
- Polymerization and light-induced heat of dental composites cured with LED and halogen technologyBiomaterials, 2003
- Degree of polymerization of resin composites by different light sourcesJournal of Oral Rehabilitation, 2002
- Effect of irradiation type (LED or QTH) on photo‐activated composite shrinkage strain kinetics, temperature rise, and hardnessEuropean Journal of Oral Sciences, 2002
- The effect of cure rate on the mechanical properties of dental resinsDental Materials, 2001
- Effect of curing with a plasma light on the properties of polymerizable dental restorative materialsJournal of Oral Rehabilitation, 2001
- Comparison between a plasma arc light source and conventional halogen curing units regarding flexural strength, modulus, and hardness of photoactivated resin compositesClinical Oral Investigations, 2000
- Light-emitting diode (LED) polymerisation of dental composites: flexural properties and polymerisation potentialBiomaterials, 2000
- Dental composite depth of cure with halogen and blue light emitting diode technologyBritish Dental Journal, 1999
- Physical properties and gap formation of light-cured composites with and without ‘softstart-polymerization’Journal of Dentistry, 1997
- Effect of Light Intensity on Polymerization of Light-cured Composite ResinsDental Materials Journal, 1994