The impact of the doping method on the structure and electrical properties of ultrathin poly(3‑butylthiophene) (P3BT) films assembled at the air-water interface is investigated. Neutral P3BT forms a well‑ordered edge‑on bilayer. Two F₄TCNQ doping strategies are compared: in situ co‑deposition of P3BT:dopant mixtures (8.5–70 mol%) directly at the interface, and sequential doping of pre‑transferred films by immersion in a dopant solution.X‑ray scattering measurements provide detailed structural insight. Grazing incidence X‑ray diffraction (GIXD) shows that both doping routes substantially alter the film organization: the π‑π stacking distance decreases from 3.85 Å to 3.66 Å, indicating polaron formation, while long‑range order along the polymer backbone is lost. Grazing incidence X‑ray scattering (GIXS) reveals an increase in the thiophene-to-thiophene vertical spacing from 12.3 to 15.5 Å, providing direct evidence for F₄TCNQ⁻ intercalation within the alkyl side‑chain interlayer. The optimal in situ doping level is obtained for a F₄TCNQ content of 15‑17 mol%. In situ UV‑visible spectroscopy further confirms efficient charge transfer and polaron generation.These structural modifications strongly influence charge transport. For five‑layer films, in situ doping achieves a conductivity of 1.4 S/cm, whereas sequential doping yields only 0.04 S/cm, corresponding to a 35‑fold enhancement. Electrochemical impedance spectroscopy demonstrates that in situ doping produces a lower-resistance network with faster charge relaxation, evidencing improved percolation across the multilayer architecture.