A Two‐Compartment Fluidized Bed Reactor for CO2 Capture by Chemical‐Looping Combustion
- 10 November 2004
- journal article
- research article
- Published by Wiley in Chemical Engineering & Technology
- Vol. 27 (12) , 1318-1326
Abstract
Chemical‐looping combustion (CLC) is a combustion method for a gaseous fuel with inherent separation of the greenhouse gas carbon dioxide. A CLC system consists of two reactors, an air reactor and a fuel reactor, and an oxygen carrier circulating between the two reactors. The oxygen carrier transfers the oxygen from the air to the fuel. The flue gas from the fuel reactor consists of carbon dioxide and water, while the flue gas from the air reactor is nitrogen from the air. A two‐compartment fluidized bed CLC system was designed and tested using a flow model in order to find critical design parameters. Gas velocities and slot design were varied, and the solids circulation rate and gas leakage between the reactors were measured. The solids circulation rate was found to be sufficient. The gas leakage was somewhat high but could be reduced by altering the slot design. Finally, a hot laboratory CLC system is presented with an advanced design for the slot and also with the possibility for inert gas addition into the downcomer for solids flow increase.Keywords
This publication has 10 references indexed in Scilit:
- Selection of Oxygen Carriers for Chemical-Looping CombustionEnergy & Fuels, 2004
- Ni based mixed oxide materials for CH4 oxidation under redox cycle conditionsJournal of Molecular Catalysis A: Chemical, 2003
- Experimental results of chemical-looping combustion with NiO/NiAl2O4 particle circulation at 1200 °CEnergy Conversion and Management, 2002
- A fluidized-bed combustion process with inherent CO2 separation; application of chemical-looping combustionChemical Engineering Science, 2001
- A novel combustor based on chemical-looping reactions and its reaction kinetics.JOURNAL OF CHEMICAL ENGINEERING OF JAPAN, 1994
- Expansion of a freely bubbling fluidized bedPowder Technology, 1991
- Effect of operating temperature on minimum fluidization velocityPowder Technology, 1991
- Solids exchange between adjacent fluid beds without gas mixingPowder Technology, 1986
- Scaling relationships for fluidized bedsChemical Engineering Science, 1984
- Estimation of bubble diameter in gaseous fluidized bedsAIChE Journal, 1975