A Comparative Study on Al0.6Ti0.4N Coatings Deposited by Cathodic Arc and HiPIMS in End Milling of Stainless Steel 316L
Open Access
Abstract
The machining of austenitic stainless steel alloys is usually characterized by high levels of adhesion and built-up edge; therefore, improving tribological conditions is fundamental to obtaining higher tool life and better surface finish. In this work, three different Al0.6Ti0.4N coatings are compared, two deposited by Cathodic Arc Evaporation (CAE) and one with High-Power Impulse Magnetron Sputtering (HiPIMS). The effects of the micromechanical properties and the microstructure of the coatings were then studied and related to the machining performance. Both arc-deposited coatings (CAE 1 and 2) exhibited similar average tool life, 127 min and 128 min, respectively. Whereas the HiPIMS lasted for only 21.2 min, the HiPIMS-coated tool had a much shorter tool life (more than six times lower than both CAE coatings) due to the intense adhesion that occurred in the early stages of the tool life. This higher adhesion ultimately caused built-up edge and chipping of the tool. This was confirmed by the cutting forces and more deformation on the shear band and undersurface of the chips, which are related to higher levels of friction. The higher adhesion could be attributed to the columnar structure of the HiPIMS and the (111) main texture, which presents a higher surface energy when compared to the dominant (200) from both arc depositions. Studies focused on tribology are necessary to further understand this relationship. In terms of micromechanical properties, tools with the highest plasticity index performed better (CAE 2 = 0.544, CAE 1 = 0.532, and HiPIMS = 0.459). For interrupted cutting machining where adhesion is the main wear mechanism, a reserve of plasticity is beneficial to dissipate the energy generated during friction, even if this was related to lower hardness levels (CAE 2 = 26.6 GPa, CAE 1 = 29.9 GPa, and HiPIMS = 33.6 GPa), as the main wear mechanism was adhesive and not abrasive.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada (NSERC) Discovery Grants (DG) Program
This publication has 48 references indexed in Scilit:
- Experimental investigation on the effect of process parameters in additive/subtractive hybrid manufacturing 316L stainless steelThe International Journal of Advanced Manufacturing Technology, 2022
- Cutting edge wear in high-speed stainless steel end millingThe International Journal of Advanced Manufacturing Technology, 2021
- Effects of cutting edge radius on cutting force, tool wear, and life in milling of SUS-316L steelThe International Journal of Advanced Manufacturing Technology, 2020
- Comparative study of PVD and CVD cutting tools performance in milling of duplex stainless steelThe International Journal of Advanced Manufacturing Technology, 2019
- Influence of helix angle on tool performances of TiAlN- and DLC-coated carbide end mills for dry side milling of stainless steelThe International Journal of Advanced Manufacturing Technology, 2016
- A study on process parameters in end milling of AISI-304 stainless steel under electrostatic minimum quantity lubrication conditionsThe International Journal of Advanced Manufacturing Technology, 2016
- Influence of pulsed substrate bias on the structure and properties of Ti–Al–N films deposited by cathodic vacuum arcApplied Surface Science, 2012
- Ti–Cu–N hard nanocomposite films prepared by pulse biased arc ion platingApplied Surface Science, 2011
- Effects of pulsed bias duty ratio on microstructure and mechanical properties of TiN/TiAlN multilayer coatingsApplied Surface Science, 2011
- An optimization method of the machining parameters in high-speed machining of stainless steel using coated carbide tool for best surface finishThe International Journal of Advanced Manufacturing Technology, 2011