Microscopic characteristics of impinging spray sliced by a cone structure under increased injection pressures
Authors:
- Hongliang LuoHongliang Luo
- Yu JinYu Jin
- Keiya NishidaKNKeiya Nishida
- Youichi OgataYOYouichi Ogata
- Jing YaoJYJing Yao
- Run ChenRCRun Chen
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (51909037)
This publication has 31 references indexed in Scilit:
- Effect of injection pressure on the impinging spray and ignition characteristics of the heavy-duty diesel engine under low-temperature conditionsApplied Energy, 2020
- Characteristics of spray and wall wetting under flash-boiling and non-flashing conditions at varying ambient pressuresFuel, 2020
- Fuel adhesion characteristics under non-evaporation and evaporation conditions: Part 2 – Effect of ambient pressureFuel, 2019
- Fuel adhesion characteristics under non-evaporation and evaporation conditions: Part 1-effect of injection pressureFuel, 2019
- Impact of coolant temperature on piston wall-wetting and smoke generation in a stratified-charge DISI engine operated on E30 fuelProceedings of the Combustion Institute, 2019
- Effect of temperature on fuel adhesion under spray-wall impingement conditionFuel, 2018
- Effects of injection pressure on spray structure after wall impingementApplied Thermal Engineering, 2018
- A numerical study of spray/wall impingement based on droplet impact phenomenonInternational Journal of Heat and Mass Transfer, 2017
- Spray development and droplet characteristics of high temperature single-hole gasoline sprayFuel, 2017
- Experimental investigation on spray-wall impingement characteristics of n-butanol/diesel blended fuelsFuel, 2016