Assessment of PMMA and polystyrene based microfluidic chips fabricated using CO2 laser machining
Authors:
- Ismail BilicanIBIsmail Bilican
- Mustafa Tahsin GulerMGMustafa Tahsin Guler
- 1 December 2020
- journal article
- research article
- Published by Elsevier in Applied Surface Science
- Vol. 534
Abstract
No abstract availableKeywords
This publication has 51 references indexed in Scilit:
- An effective method for fabricating microchannels on the polycarbonate (PC) substrate with CO2 laserThe International Journal of Advanced Manufacturing Technology, 2017
- Low cost microfluidic device for partial cell separation: Micromilling approach2015
- Fabrication of a circular PDMS microchannel for constructing a three-dimensional endothelial cell layerBioprocess and Biosystems Engineering, 2013
- Fabrication of polystyrene microfluidic devices using a pulsed CO2 laser systemMicrosystem Technologies, 2011
- Evaluation of cutting quality of PMMA using CO2 lasersThe International Journal of Advanced Manufacturing Technology, 2006
- Micromachining of complex channel systems in 3D quartz substrates using Q-switched Nd:YAG laserApplied Physics A, 2002
- Kinetics of the Thermal and Thermo-Oxidative Degradation of Polystyrene, Polyethylene and Poly(propylene)Macromolecular Chemistry and Physics, 2001
- Rapid Prototyping of Microfluidic Systems in Poly(dimethylsiloxane)Analytical Chemistry, 1998
- UV Laser Machined Polymer Substrates for the Development of Microdiagnostic SystemsAnalytical Chemistry, 1997
- Femtosecond, picosecond and nanosecond laser ablation of solidsApplied Physics A, 1996