Phase stabilization of plasma-sprayed alumina coatings by spraying mechanically blended alumina–chromia powders
- 21 June 2016
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 32 (4) , 355-364
Abstract
A study of phase stabilization is performed on atmospheric plasma-sprayed alumina–chromia coating applied on low-carbon steel substrates. Alumina–chromia mixture with varying amounts of chromia content (1 wt.% to 6 wt.%) is used for this purpose. X-ray diffraction (XRD) analysis is carried out to investigate the different phase compositions of the coatings. Quantification of the different phases present in the coatings is performed by subsequent use of Rietveld refinement method. Surface morphology, microhardness, and wear behavior of the different coatings are also observed. Rietveld analyses performed on coatings ensure the stabilization of metastable phases present in the alumina coatings by chromia addition. Significant increase of the α -alumina and (AlxCr1-x)2O3 content is observed in alumina coatings with 4 wt.% chromia content. This is supported by the improved hardness and wear-resistant properties of the alumina coatings containing 4 wt.% chromia. The minimum surface roughness of the coating is also observed for alumina coatings with 4 wt.% chromia content among all the alumina coatings with different chromia content. The formation of alumina–chromia solid solution and solidification of α-alumina are found to be the reasons behind the enhancement in mechanical properties of the coating.Keywords
Funding Information
- Financial support from the Science and Engineering Research Board, Department of Science & Technology (DST), Government of India, is gratefully acknowledged.
This publication has 26 references indexed in Scilit:
- Sliding Wear Performance of Plasma-Sprayed Al2O3-Cr2O3 Composite Coatings Against Graphite under Severe ConditionsJournal of Thermal Spray Technology, 2013
- Microstructure and mechanical properties of Al2O3–Cr2O3 composite coatings produced by atmospheric plasma sprayingSurface and Coatings Technology, 2011
- Wear Behavior of Plasma-Sprayed Al-12Si/SiC Composite Coatings under Dry and Water-Lubricated SlidingMaterials and Manufacturing Processes, 2009
- Evaluation of fracture toughness of as plasma sprayed alumina–13wt.% titania coatings by micro-indentation techniquesJournal of the European Ceramic Society, 2006
- Effect of some parameters on microstructure and hardness of alumina coatings prepared by the air plasma spraying processSurface and Coatings Technology, 2005
- Sol infiltration and heat treatment of alumina–chromia plasma-sprayed coatingsJournal of the European Ceramic Society, 2001
- Size-dependent melting point depression of nanostructures: Nanocalorimetric measurementsPhysical Review B, 2000
- Tribological Evaluation of Plasma Sprayed Coatings for High Temperature Sliding Surface Against CordieriteMaterials and Manufacturing Processes, 1999
- Formation of continuous series of solid solutions from powders prepared by hydrazine method: The system Cr2O3-Al2O3Materials Research Bulletin, 1996
- Peak shape variation in fixed-wavelength neutron powder diffraction and its effect on structural parameters obtained by Rietveld analysisJournal of Applied Crystallography, 1985