Multi-Threshold Inertial Switch for Quantitative Acceleration Measurements
- 22 September 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (21) , 23849-23859
Abstract
This paper presents a multi-threshold inertial switch demonstrated experimentally and through simulation. A laterally-driven multi-threshold inertial switch based on SOIMUMPs has been fabricated. The device has been tested by a drop-table test system under different shock accelerations with various amplitudes and pulse widths. In addition to experimental data, finite element simulation has been used to further assess the device’s performance. The designed switch is a 2-axis device capable of triggering in all directions in a single plane. This work demonstrates that the designed inertial switch with 3 threshold levels can perform quantitative acceleration measurements while saving power when not activated. The multi-threshold inertial switch can sense a shock range of 800g–2600g. The same device principle can be extended for a higher number of bits. The axial disturbance performance shows that the inertial switch has high single-axial sensitivity and low axial cross-talk.Keywords
Funding Information
- King Abdullah University of Science and Technology
This publication has 34 references indexed in Scilit:
- Design, fabrication and characterization of a latching acceleration switch with multi-contacts independent to the proof-massSensors and Actuators A: Physical, 2011
- Latching in a MEMS shock sensor: Modeling and experimentsSensors and Actuators A: Physical, 2010
- Fabrication of a MEMS inertia switch on quartz substrate and evaluation of its threshold accelerationMicroelectronics Journal, 2008
- Characterization of the performance of capacitive switches activated by mechanical shockJournal of Micromechanics and Microengineering, 2007
- Investigation of the response of microstructures under the combined effect of mechanical shock and electrostatic forcesJournal of Micromechanics and Microengineering, 2006
- Acceleration switch with extended holding time using squeeze film effect for side airbag systemsSensors and Actuators A: Physical, 2002
- A wide-range micromachined threshold accelerometer array and interface circuitJournal of Micromechanics and Microengineering, 2001
- Additive electroplating technology as a post-CMOS process for the production of MEMS acceleration-threshold switches for transportation applicationsJournal of Micromechanics and Microengineering, 2000
- Low-cost post-CMOS integration of electroplated microstructures for inertial sensingSensors and Actuators A: Physical, 2000
- Micromechanical switches fabricated using nickel surface micromachiningJournal of Microelectromechanical Systems, 1997