Design optimization of surface acoustic wave devices and investigation of fabricated devices under temperature, humidity and steam environments
- 19 June 2024
- journal article
- research article
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (7) , 075970
Abstract
Surface Acoustic Wave (SAW) technique is one of the most promising Micro Electro Mechanical Systems (MEMS) based detection methods for a variety of applications. SAW sensor is based on the modulation of Rayleigh waves that travel near the surface of a piezoelectric substrate. Advent of MEMS technology has led to the development of SAW sensors which are widely used in chemical sensing, medical, industrial, telecommunication and biological applications. The main focus of this paper is to devise and characterize a generic SAW structure and study the acoustic properties at various environmental conditions before depositing the sensing layer/analyte for any particular application. In this work, a SAW device was designed using COMSOL Multiphysics for a resonant frequency of 100 MHz with 40 μm wavelength on Lithium Niobate (LiNbO3) piezoelectric substrate. The optimized device structure was fabricated using thin film deposition and UV photolithography. The resonant frequency of the fabricated device (97.63 MHz) matched closely with the simulation results (100 MHz) and theoretical results (100 MHz). The device was subjected to various environmental conditions to study the influence on the resonant frequency. The SAW structure showed a resonant frequency shift of 90 KHz in steam environment, ∼ 1 MHz when heated to 150 °C and ∼ 120 KHz when exposed to 80% RH. The device exhibited a linear shift in resonant frequency under all tested environmental conditions with a consistent baseline and good repeatability.Keywords
Funding Information
- Board of Research in Nuclear Sciences (59/14/04/2019-BRNS/34100)
This publication has 33 references indexed in Scilit:
- Gigahertz Low-Loss Surface Acoustic Wave Devices Based on ScAlN/Si StructuresJournal of Electronic Materials, 2023
- Multiphysics modeling of printed surface acoustic wave thermometersSensors and Actuators A: Physical, 2023
- Surface acoustic wave temperature sensor based on Pt/AlN/4 H-SiC structure for high-temperature environmentsSensors and Actuators A: Physical, 2023
- Surface Acoustic Wave Humidity Sensor Based on Hydrophobic Polymer FilmJournal of Electronic Materials, 2022
- A Low-Cost Fabrication and Numerical Simulation of a MEMS Acoustic Transducer Using Polyimide Membrane on FR4 SubstrateJournal of Electronic Materials, 2021
- Design study of hydrogen monitoring equipment for severe accident in containment of nuclear power plantEnergy Reports, 2020
- Comprehensive characterization of ZnO thin films for surface acoustic wave applicationsJournal of Materials Science: Materials in Electronics, 2019
- Temperature measurements using a lithium niobate (LiNbO3) pyroelectric ceramicMeasurement, 2015
- Highly sensitive surface acoustic wave (SAW) humidity sensors based on sol–gel SiO2 films: Investigations on the sensing property and mechanismSensors and Actuators B: Chemical, 2015
- 3D FE simulation of H2 SAW gas sensorSensors and Actuators B: Chemical, 2005