Electrochemical Properties and Discharge Mechanism of Na/TiS2Cells with Liquid Electrolyte at Room Temperature
Authors:
- 13 December 2012
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 160 (2) , A338-A343
Abstract
The electrochemical properties of Na/TiS2 cells fabricated from Na anodes and TiS2 cathodes and 1M sodium trifluoromethanesulfonate in tetraethyleneglycol dimethylether liquid electrolyte have been investigated. The discharge curve has two plateau regions of 2.1 V and 1.6 V. The loss of discharge capacity appeared mainly in the upper plateau (UP) region (2.0–2.6 V) and the discharge capacity in the low plateau (LP) region (0.8–2.0 V) does not decrease and is consistent during 40 cycles. The discharge process between Na and TiS2 has a complex reaction mechanism, the intercalation at the upper plateau region and the conversion at the low plateau region. Because, a distorted TiS2 phase appeared in the upper plateau, a new phase of NaxTiS2 was observed in the lower plateau, and the NaxTiS2 phase was disappeared after full discharge from the XRD and TEM results. The decrease of discharge capacity during cycling is occurred from the formation of NaxTiS2 phase in the cathode after full charging and is accumulated over cyclingKeywords
This publication has 19 references indexed in Scilit:
- Studies on poly(vinylidene fluoride-co-hexafluoropropylene) based gel electrolyte nanocomposite for sodium–sulfur batteriesSolid State Ionics, 2011
- Challenges for Na-ion Negative ElectrodesJournal of the Electrochemical Society, 2011
- The addition of iron to Ni3S2 electrode for sodium secondary batteryCurrent Applied Physics, 2011
- Electrochemical Properties of NaTi2(PO4)3 Anode for Rechargeable Aqueous Sodium-Ion BatteriesJournal of the Electrochemical Society, 2011
- The discharge properties of Na/Ni3S2 cell at ambient temperatureJournal of Power Sources, 2008
- The short-term cycling properties of Na/PVdF/S battery at ambient temperatureJournal of Solid State Electrochemistry, 2008
- Electrochemical characteristics of Na/FeS2 battery by mechanical alloyingJournal of Alloys and Compounds, 2008
- Electrochemical properties of sodium/pyrite battery at room temperatureJournal of Power Sources, 2007
- Discharge properties of all-solid sodium–sulfur battery using poly (ethylene oxide) electrolyteJournal of Power Sources, 2007
- Room-Temperature Solid-State Sodium∕Sulfur BatteryElectrochemical and Solid-State Letters, 2006