Effects of Injection Molding Screw Tips on Polymer Mixing
Open Access
- 16 May 2018
- journal article
- research article
- Published by Periodica Polytechnica Budapest University of Technology and Economics in Periodica Polytechnica Mechanical Engineering
- Vol. 62 (3) , 241-246
Abstract
In all fields of industry it is important to produce parts with good quality. Injection molded parts usually have to meet strict requirements technically and aesthetically. The aim of the measurements presented in our paper is to investigate the aesthetic appearance, such as surface color homogeneity, of injection molded parts. It depends on several factors, the raw material, the colorants, the injection molding machine and the processing parameters. In this project we investigated the effects of the injection molding machine on surface color homogeneity. We focused on injection molding screw tips and investigated five screw tips with different geometries. We produced flat specimens colored with a masterbatch and investigated color homogeneity. To evaluate the color homogeneity of the specimens, we used digital image analysis software developed by us. After that we measured the plastication rate and the melt temperature of the polymer melt because mixing depends on these factors. Our results showed that the screw tips (dynamic mixers) can improve surface color homogeneity but they cause an increase in melt temperature and a decrease in the plastication rate.Keywords
This publication has 17 references indexed in Scilit:
- Evaluation of the homogenization properties of masterbatchesColoration Technology, 2017
- The Effect of Masterbatch Recipes on the Homogenization Properties of Injection Molded PartsInternational Journal of Polymer Science, 2017
- Image analysis operations applied to hyperspectral images for non-invasive sensing of food quality – A comprehensive reviewBiosystems Engineering, 2016
- Image Processing for Identification of Sea-Ice Floes and the Floe Size DistributionsIEEE Transactions on Geoscience and Remote Sensing, 2014
- Development of a novel color inhomogeneity test method for injection molded partsPolymer Testing, 2014
- Polymer powders mixing part II: Multi-component mixing dynamics using RGB color analysisChemical Engineering Science, 2010
- Analysis of agglomerate dispersion mechanisms of multiwalled carbon nanotubes during melt mixing in polycarbonatePolymer, 2010
- Determination of the mixing time in a discontinuous powder mixer by using image analysisChemical Engineering Science, 2009
- Development of methods for the quantification of microstructural features in α+β-processed α/β titanium alloysMaterials Science and Engineering: A, 2009
- The cavity transfer mixer: A blender for all seasoningsMaterials & Design (1980-2015), 1987