A modified barbell-shaped PNN-PZT-PIN piezoelectric ceramic energy harvester
- 20 November 2017
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 111 (21)
Abstract
The quaternary system of relaxor-ferroelectric based Pb(Ni1/3Nb2/3)O3-Pb(ZrxTi1−x)O3-Pb(In0.5Nb0.5)O3 (PNN-PZT-PIN) piezoelectric ceramic at the morphotropic phase boundary was investigated via the solid reaction method. The optimized ceramic with excellent electric properties of εr = 8084, d33 = 977 pC/N, kp = 0.61, and Ec = 3.0 kV/cm was fabricated into d33-mode discs with separated surface electrodes, which were arranged in a series connection and, then as a piezo-stack, assembled into a barbell-shaped energy harvester that could bear a strong mechanical vibration. It is found that under a vibration mass-induced bending moment, the energy harvester produces an open circuit voltage of 26.4 Vp-p at the acceleration of 2.5 g at a load of 1.56 MΩ, which is two times higher in comparison to one without surface electrode separation. Its power output is 30 μW at the acceleration of 1 g and 104 μW at 2.5 g, which are even six times higher than that of a previously reported barbell-shaped energy harvester at room-temperature with the same acceleration. The enhanced power output can be attributed to (i) the excellent piezoelectric response of PNN-PZT-PIN ceramic and (ii) harvesting positive and negative charges from the separated surface electrodes other than a full surface electrode on piezoelectric discs under bending moment. Furthermore, the practical test was performed within a car engine, which shows that the PNN-PZT-PIN piezoelectric ceramic is a promising candidate for vibration energy harvesting.Keywords
Funding Information
- National Natural Science Foundation of China (51132001, 51772005)
This publication has 21 references indexed in Scilit:
- A comprehensive review on vibration energy harvesting: Modelling and realizationRenewable and Sustainable Energy Reviews, 2017
- Performance of ZnO based piezo-generators under controlled compressionSemiconductor Science and Technology, 2017
- A flexible, wave-shaped P(VDF-TrFE)/metglas piezoelectric composite for wearable applicationsJournal of Applied Physics, 2016
- Parametric study on a collocated PZT beam vibration absorber and power harvesterJournal of Mechanical Science and Technology, 2016
- A barbell-shaped high-temperature piezoelectric vibration energy harvester based on BiScO3-PbTiO3 ceramicApplied Physics Letters, 2016
- Comparison of PZN-PT, PMN-PT single crystals and PZT ceramic for vibration energy harvestingEnergy Conversion and Management, 2016
- Low frequency piezoelectric energy harvesting at multi vibration mode shapesSensors and Actuators A: Physical, 2015
- Piezoelectric and ferroelectric materials and structures for energy harvesting applicationsEnergy & Environmental Science, 2013
- On Mechanical Modeling of Cantilevered Piezoelectric Vibration Energy HarvestersJournal of Intelligent Material Systems and Structures, 2008
- A review of power harvesting using piezoelectric materials (2003–2006)Smart Materials and Structures, 2007