Dispersion mechanism-induced variations in microstructural and mechanical behavior of CNT-reinforced aluminum nanocomposites
Open Access
- 24 January 2022
- journal article
- research article
- Published by Springer Nature in Archives of Civil and Mechanical Engineering
- Vol. 22 (1) , 1-17
Abstract
The combination of powder metallurgy and ball milling method has been widely regarded as the most beneficial route for producing multi-walled carbon nanotubes (MWCNTs)-reinforced aluminum matrix composites. In this study, the effects of different milling times (1, 2, 4, and 8 h) on the structural, morphological, and crystallographic properties of MWCNTs-reinforced Al7075 composite powders were characterized by particle size analyzer, Raman spectroscopy, scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HR-TEM), and X-ray diffraction (XRD). After the morphological and structural characterization of the milled powders, the microstructural and mechanical properties of the hot-pressed composites were evaluated using an optical microscope, SEM, density, and Brinell hardness measurements. Considering milled powder characterization, the MWCNTs were gradually distributed and embedded within the matrix as the milling time increased. Milling for 8 h resulted in a minimum level of particle size (11 µm) with shortened and uniformly dispersed CNTs. Brinell hardness of the composite increased from 91 to 237 HB -a ⁓%160 after 8 h of milling. Such a remarkable increment in hardness could be attributed to several concurrent strengthening effects related to dispersion, solution, grain refinement, and Orowan looping mechanisms. However, relative density results revealed that the composite produced by 2 h milled powders exhibited the highest density (%99.96). The observed differences between hardness and density results were ascribed to powders’ deteriorated packing and sintering behavior due to an increment in the hardness of particles and variation in particle size range and morphology, which resulted from following different milling protocols.Keywords
This publication has 68 references indexed in Scilit:
- Multi-Walled Carbon Nanotube-Aluminum Matrix Composites Prepared by Combination of Hetero-Agglomeration Method, Spark Plasma Sintering and Hot ExtrusionMATERIALS TRANSACTIONS, 2011
- CNT reinforced light metal composites produced by melt stirring and by high pressure die castingComposites Science and Technology, 2010
- Investigation of carbon nanotube reinforced aluminum matrix composite materialsComposites Science and Technology, 2010
- Structural characterization of a mechanically milled carbon nanotube/aluminum mixtureComposites Part A: Applied Science and Manufacturing, 2009
- Fabrication and properties of dispersed carbon nanotube–aluminum compositesMaterials Science and Engineering: A, 2009
- Fabrication and tribological properties of carbon nanotubes reinforced Al composites prepared by pressureless infiltration techniqueComposites Part A: Applied Science and Manufacturing, 2007
- Structure and properties of aluminium cast composites strengthened by dispersion phasesJournal of Materials Processing Technology, 2006
- Microstructure evaluation of Al–Al2O3 composite produced by mechanical alloying methodMaterials & Design (1980-2015), 2006
- Strengthening in carbon nanotube/aluminium (CNT/Al) compositesScripta Materialia, 2005
- Structural characterization of hot wall deposited cadmium selenide thin filmsSemiconductor Science and Technology, 1998