Experimental and microstructural investigation on the strength and frost resistance of basalt fiber reinforced steel slag foamed concrete
Authors:
Open Access
- 12 March 2026
- journal article
- Published by Springer Nature in Scientific Reports
- Vol. 16 (1)
Abstract
Aiming to facilitate the high-value repurposing of industrial steel slag, this investigation synthesized basalt fiber-reinforced steel-slag foamed concrete (BFSFC) incorporating fiber volume fractions of 0%, 0.15%, 0.30%, and 0.45%. The experimental study assessed compressive and flexural capacities alongside resistance to freeze-thaw cycling, while micro-void was reconstructed via X-ray CT and corroborated by SEM imaging. Grey Relational Analysis (GRA) was subsequently utilized to correlate pore metrics with strength degradation under freezing conditions. Empirical findings identify 0.30% as the critical fiber volume fraction; this optimal mix yielded a 28-day compressive strength of 1.322 MPa (a 12.03% increment over the reference) and elevated flexural strength to 0.517 MPa (an increase of approximately 64%). Following 15 freeze-thaw iterations, the BFSFC2 specimen maintained a mass loss below 5% and restricted strength deterioration to 8.69%, a sharp contrast to the 31.14% decay observed in the control group. Microscopic analysis attributes this stability to a fiber-induced reduction in pore network complexity and morphological refinement. Furthermore, GRA confirms that fiber dosage exhibits the strongest correlation with fractal dimension (0.991), whereas frost-induced strength decline is primarily governed by fractal dimension (0.805) and large pore size (> 200 μm, 0.743), highlighting the dominance of pore network complexity and large pore-defects in freezing behavior. Conclusively, BFSFC2 provides a balanced improvement in mechanical performance and freeze-thaw resistance, supporting a microstructure-based optimization route for producing lightweight foamed concrete using steel slag for cold regions.Keywords
Funding Information
- Project Supported by Scientific Research Fund of Zhejiang Provincial Education Department (Grant No. Y202352448)
This publication has 49 references indexed in Scilit:
- E-waste in concrete construction: recycling, applications, and impact on mechanical, durability, and thermal properties—a reviewInnovative Infrastructure Solutions, 2025
- Seismic safety assessment of buildings and perceptions of earthquake risk among communities in Mingora, Swat, PakistanInnovative Infrastructure Solutions, 2025
- Characterisation of alkali-activated stainless steel slag and blast-furnace slag cementsCement and Concrete Composites, 2023
- Recycling of ironmaking and steelmaking slags in Japan and ChinaInternational Journal of Minerals, Metallurgy and Materials, 2022
- Bio-based ultra-lightweight concrete applying miscanthus fibers: Acoustic absorption and thermal insulationCement and Concrete Composites, 2020
- Carbonation of steel slag and gypsum for building materials and associated reaction mechanismsCement and Concrete Research, 2019
- Utilization of carbonated and granulated steel slag aggregate in concreteConstruction and Building Materials, 2015
- Recycled aggregate from C&D waste & its use in concrete – A breakthrough towards sustainability in construction sector: A reviewConstruction and Building Materials, 2014
- The use of steel slag aggregate to enhance the mechanical properties of recycled aggregate concrete and retain the environmentConstruction and Building Materials, 2014
- Porosimetry of Fractal SurfacesJournal of Colloid and Interface Science, 1993