Experimental Study on Diffusion Law of Post‐Grouting Slurry in Sandy Soil
Authors:
Open Access
- 1 January 2019
- journal article
- research article
- Published by Wiley in Advances in Civil Engineering
- Vol. 2019 (1)
Abstract
In order to study the diffusion law of grouting slurry in sand areas, the grouting of cement slurry in sand was analyzed by the indoor grouting test under different water‐cement ratios, grouting pressures, grouting amounts, and soil qualities, and the law of the post‐grouting slurry is obtained. The results show that the grouting method is affected by the grouting pressure, water‐cement ratio, grouting amount, and soil quality. Under the same grouting pressure, the diffusion modes of different water‐cement ratio grouts in sands with different permeability coefficients, which are mainly manifested as osmotic diffusion, are basically the same; under the same water‐cement ratio, when the grouting pressure is relatively small, the diffusion of modes of slurry is mainly osmotic in sand. The diffusion radius of cement slurry in sand has a good power function relationship with grouting pressure, water‐cement ratio, permeability coefficient, and grouting amount. And, the empirical function model of slurry diffusion radius is proposed by regression analysis. The research results provide a certain theoretical and experimental reference for post‐grouting in sandy areas.Keywords
Funding Information
- Hunan Department of Housing and Urban-Rural Development (KY2016082)
This publication has 35 references indexed in Scilit:
- Behavior and Modeling of Fiber-Reinforced Clay under Triaxial Compression by Combining the Superposition Method with the Energy-Based Homogenization TechniqueInternational Journal of Geomechanics, 2018
- Fracture of brittle and quasi-brittle materials in compression: A review of the current state of knowledge and a different approachTheoretical and Applied Fracture Mechanics, 2018
- A new mixed mode I/II fracture test specimen: Numerical and experimental studiesTheoretical and Applied Fracture Mechanics, 2018
- Fracture toughness and damage development in limpet shellsTheoretical and Applied Fracture Mechanics, 2018
- Utilisation of GIS Concepts for Foundation Design on Problematic Eastern Saudi Arabian Sabkha SoilGeotechnical and Geological Engineering, 2018
- Laboratory Investigation on Strength Characteristics of Expansive Soil Treated with Jute Fiber ReinforcementInternational Journal of Geomechanics, 2017
- Technological assessment of tailings from quartzite mining sites in Alpinópolis (Minas Gerais–Brazil) as aggregates in concrete block paving (CBP)Bulletin of Engineering Geology and the Environment, 2017
- Correlation of UCS Rating with Schmidt Hammer Surface Hardness for Rock Mass ClassificationRock Mechanics and Rock Engineering, 2016
- Detection of mine slope motions in Brazil as revealed by satellite radar interferogramsBulletin of Engineering Geology and the Environment, 2015
- Stress function determination for dislocation configurations obtained from Kröner’s theoryTheoretical and Applied Fracture Mechanics, 2006