Strategy for Surface Post-Processing of AISI 316L Additively Manufactured by Powder Bed Fusion Using Ultrasonic Nanocrystal Surface Modification
Open Access
Abstract
Ultrasonic nanocrystal surface modification (UNSM) technology was applied to the surfaces of specimens additively manufactured by powder bed fusion (PBF). The changes in roughness and hardness due to the UNSM were set as objective functions, and the optimal conditions for the main parameters were derived through the response surface method (RSM) and Box–Behnken design (BBD). Regression analysis-based mathematical models for predicting the surface hardness and roughness are presented and validated. The RSM results show that the surface roughness is highly dependent on the load and ball tip diameter, and the surface roughness significantly improves as the inter-pass interval and ball tip diameter decrease. Through BBD and ANOVA, the optimal conditions for the improvement of surface characteristics were found to be a load of 40 N, inter-pass interval of 10 μm, and ball tip diameter of 2.38 m. The surface treated under these optimal conditions exhibited a hardness of 497 Hv and surface roughness of 1.32 μm, which were significantly improved compared to the values for an untreated specimen. In addition, it was confirmed that the grains are significantly refined after UNSM, and scratch resistance increases for the top layer of the surface directly affected by the UNSM horn.Keywords
Funding Information
- Korea Institute for Advancement of Technology (G02P03040000701)
This publication has 36 references indexed in Scilit:
- Better Surface Integrity and Tribological Properties of Steel Sintered by Powder MetallurgyMaterials, 2020
- Effect of shot peening coverage on hardness, residual stress and surface morphology of carburized rollersSurface and Coatings Technology, 2020
- Effect of the Ultrasonic Nanocrystalline Surface Modification (UNSM) on Bulk and 3D-Printed AISI H13 Tool SteelsMetals, 2017
- Nanostructured β-type titanium alloy fabricated by ultrasonic nanocrystal surface modificationUltrasonics Sonochemistry, 2017
- Changes in Mechanical Properties of WC-Co by Ultrasonic Nanocrystal Surface Modification TechniqueJournal of the Korean Society of Tribologists and Lubrication Engineers, 2015
- Effects of Shot Peening Time on Microstructure and Electrochemical Characteristics for Cu AlloyJournal of the Korean Society of Marine Environment & Safety, 2013
- Microscopic Analysis of Effect of Shot Peening on Corrosion Fatigue Behavior of Aluminum AlloyTransactions of the Korean Society of Mechanical Engineers - A, 2012
- Influence of time on the microstructure of AISI 321 austenitic stainless steel in salt bath nitridingSurface and Coatings Technology, 2012
- Micro-Shockwave Measurement and Evaluation of Laser Shock PeeningTransactions of the Korean Society of Mechanical Engineers - B, 2011
- The Influence of Treatment Condition During Low Temperature Plasma Carburizing of AISI304L Stainless SteelJournal of Ocean Engineering and Technology, 2011