A numerical investigation and experimental validation on chip morphology of Aluminum Alloy 6061 during orthogonal machining
- 1 April 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 331-336
Abstract
In this research work, Aluminum alloy Al6061-T6 was machined in order to investigate the chip morphology at different cutting parameters. Chip morphology with different shapes and sizes affects various aspects such as cutting force, chatter stability and cutting temperature which in turn influences workpiece surface quality, tool life, and machining efficiency. Orthogonal cutting experiments were carried out with the CCMW 09 T3 04-H13A uncoated carbide tool in the cutting speed range of 250-1,000 m/min and feed rate of 0.1-0.4 mm/r to obtain the chip thicknesses and the shear angles. Commercially available software Abaqus/Explicit was used to simulate a 2D orthogonal model. The simulation results were found to be in close agreement with the experimental results and showed that chip thickness decreased with increasing cutting speed whereas shear angle increased with the increase of cutting speed.Keywords
This publication has 7 references indexed in Scilit:
- Experimental investigation on 3D chip morphology properties of rotary surface during orthogonal turn-milling of aluminum alloyThe International Journal of Advanced Manufacturing Technology, 2015
- Research on chip formation parameters of aluminum alloy 6061-T6 based on high-speed orthogonal cutting modelThe International Journal of Advanced Manufacturing Technology, 2014
- Sub-surface and surface analysis of high speed machined Ti–6Al–4V alloyMaterials Science and Engineering: A, 2010
- Characteristics of aluminum 6061-T6 deformed to large plastic strains by machiningMaterials Science and Engineering: A, 2005
- On predicting chip morphology and phase transformation in hard machiningThe International Journal of Advanced Manufacturing Technology, 2005
- A FEM study on mechanisms of discontinuous chip formation in hard machiningJournal of Materials Processing Technology, 2004
- Microstructures and mechanical properties of 6061 aluminum alloy processed by accumulative roll-bondingMaterials Science and Engineering: A, 2002