Cu2+‐doped Carbon Nitride/MWCNT as an Electrochemical Glucose Sensor
- 30 March 2018
- journal article
- research article
- Published by Wiley in Electroanalysis
- Vol. 30 (7) , 1446-1454
Abstract
The rational design of electrocatalysts with abundant active sites and high conductivity is the key to the development of glucose sensors. Herein, we report the preparation of a Cu2+‐doped C3N4 supported on multi‐walled carbon nanotube (MWCNT) network (Cu2+‐C3N4/MWCNT) as a highly efficient non‐enzymatic glucose sensing system. The morphologic and structural investigations using TEM, AFM, XRD, XPS, EPR, and i‐V response indicate the successful insertion of Cu2+ into the C3N4 inter‐layers via an out‐of‐plane on‐top configuration and the consequent exfoliation of C3N4 layers without forming CuO or Cu(OH)2. Such material can act as an electrocatalyst for glucose electrooxidation, and MWCNT can greatly reduce the charge transfer resistance and enhances activity. An optimised Cu2+ doping level (12 wt%) in Cu2+‐C3N4/MWCNT was established to realise high sensitivity towards glucose sensing (929 mA/M cm2), large linear range (0.5 μM∼12 mM), low detection limit (0.35 μM), and short response time (<3 s). Excellent selectivity against the interferents, such as dopamine, ascorbic acid, sucrose, and lactose, is also observed. In the blood serum tests, as‐prepared glucose sensor reports comparable and reproducible results, demonstrating its practical potentials.Keywords
Funding Information
- Hong Kong Polytechnic University
This publication has 29 references indexed in Scilit:
- Crystal structure of polymeric carbon nitride and the determination of its process-temperature-induced modificationsJournal of Physics: Condensed Matter, 2013
- Synthesis of CuO/graphene nanocomposites for nonenzymatic electrochemical glucose biosensor applicationsElectrochimica Acta, 2012
- Graphitic carbon nitride (g-C3N4)–Pt-TiO2 nanocomposite as an efficient photocatalyst for hydrogen production under visible light irradiationPhysical Chemistry Chemical Physics, 2012
- Simple pyrolysis of urea into graphitic carbon nitride with recyclable adsorption and photocatalytic activityJournal of Materials Chemistry, 2011
- An improved sensitivity nonenzymatic glucose biosensor based on a Cu O modified electrodeBiosensors and Bioelectronics, 2010
- A highly sensitive nonenzymatic glucose sensor based on CuO nanoparticles-modified carbon nanotube electrodeBiosensors and Bioelectronics, 2010
- Synthesis of CuO nanostructures and their application for nonenzymatic glucose sensingSensors and Actuators B: Chemical, 2010
- Carbon Nitride as a Nonprecious Catalyst for Electrochemical Oxygen ReductionThe Journal of Physical Chemistry C, 2009
- CuO Nanospheres Based Nonenzymatic Glucose SensorElectroanalysis, 2008
- Electrochemical non-enzymatic glucose sensorsAnalytica Chimica Acta, 2006