Effect of Cavity Depth and Application Technique on Marginal Adaptation of Resins in Dentin Cavities
Author:
- 1 November 1986
- journal article
- research article
- Published by SAGE Publications in Journal of Dental Research
- Vol. 65 (11) , 1319-1321
Abstract
The wall-to-wall polymerization contraction of two restorative resins was investigated in butt-joint dentin cavities prepared in extracted human teeth. The cavity diameter was 4 mm, and the cavity depth ranged between 0.5 and 3.0 mm. The width of the maximum marginal contraction gap was measured, using a light microscope, approximately 0.1 mm below the original free surfaces of the fillings. It was found that increasing the cavity depth from 0.5 to 3.0 mm did not influence the marginal contraction gap close to the free surfaces of the fillings. It was also found that a two-phase application technique, where the surface of the first layer was placed parallel to the free surface of the cavity, did not reduce the marginal contraction gap, while a two-phase technique with oblique layers resulted in approximately a 25% reduction.Keywords
This publication has 7 references indexed in Scilit:
- The Competition between the Composite-Dentin Bond Strength and the Polymerization Contraction StressJournal of Dental Research, 1984
- Polymerization shrinkage of resin‐based restorative materialsAustralian Dental Journal, 1983
- Clinical Placement and Performance of Composite Resin RestorationsJournal of Dental Research, 1979
- Composite restorative resins: Composition versus wall-to-wall polymerization contractionActa Odontologica Scandinavica, 1975
- Physical Properties and Finished Surface Texture of Composite Restorative ResinsThe Journal of the American Dental Association, 1972
- Physical Properties of Four Thermosetting Dental Restorative ResinsJournal of Dental Research, 1969
- Adhesive bonding of various materials to hard tooth tissues. VI. Forces developing in direct-filling materials during hardeningThe Journal of the American Dental Association, 1967