Interconnection between microstructure and microhardness of directionally solidified binary Al-6wt.%Cu and multicomponent Al-6wt.%Cu-8wt.%Si alloys
Open Access
- 31 May 2016
- journal article
- Published by FapUNIFESP (SciELO) in Anais da Academia Brasileira de Ciências
- Vol. 88 (2) , 1099-1111
Abstract
An experimental study has been carried out to evaluate the microstructural and microhardness evolution on the directionally solidified binary Al-Cu and multicomponent Al-Cu-Si alloys and the influence of Si alloying. For this purpose specimens of Al-6wt.%Cu and Al-6wt.%Cu-8wt.%Si alloys were prepared and directionally solidified under transient conditions of heat extraction. A water-cooled horizontal directional solidification device was applied. A comprehensive characterization is performed including experimental dendrite tip growth rates (VL) and cooling rates (TR) by measuring Vickers microhardness (HV), optical microscopy and scanning electron microscopy with microanalysis performed by energy dispersive spectrometry (SEM-EDS). The results show, for both studied alloys, the increasing of TR and VL reduced the primary dendrite arm spacing (l1) increasing the microhardness. Furthermore, the incorporation of Si in Al-6wt.%Cu alloy to form the Al-6wt.%Cu-8wt.%Si alloy influenced significantly the microstructure and consequently the microhardness but did not affect the primary dendritic growth law. An analysis on the formation of the columnar to equiaxed transition (CET) is also performed and the results show that the occurrence of CET is not sharp, i.e., the CET in both cases occurs in a zone rather than in a parallel plane to the chill wall, where both columnar and equiaxed grains are be able to exist.Keywords
This publication has 22 references indexed in Scilit:
- Growth direction and Si alloying affecting directionally solidified structures of Al–Cu–Si alloysMaterials Science and Technology, 2015
- Measurements of microhardness during transient horizontal directional solidification of Al-Rich Al-Cu alloys: Effect of thermal parameters, primary dendrite arm spacing and Al2Cu intermetallic phaseMetals and Materials International, 2015
- The Growth of Secondary Dendritic Arms in Directionally Solidified Al-Si-Cu Alloys: A Comparative Study with Binary Al-Si AlloysApplied Mechanics and Materials, 2015
- Characterization of the Al-3wt.%Si alloy in unsteady-state horizontal directional solidificationMaterials Research, 2013
- Effect of solidification parameters on mechanical properties of directionally solidified Al-Rich Al-Cu alloysMetals and Materials International, 2013
- The heat treatment of Al–Si–Cu–Mg casting alloysJournal of Materials Processing Technology, 2010
- Numerical and experimental investigation of microporosity formation in a ternary Al–Cu–Si alloyJournal of Alloys and Compounds, 2010
- Effect of Alloy Composition on the Dendrite Arm Spacing of Multicomponent Aluminum AlloysMetallurgical and Materials Transactions A, 2010
- Simulation of the three-dimensional morphology of solidification porosity in an aluminium–silicon alloyActa Materialia, 2003
- The directional solidification of Pb-Sn alloysJournal of Materials Science, 2000