Bearing Fault Diagnostics Based on the Square of the Amplitude Gains Method
Open Access
- 8 February 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (4) , 2160
Abstract
The article presents an adaptation of a parametric diagnostic method based on the square of the amplitude gains model, which was tested in experimental studies on bearing damage detection (outer race, inner race, bearing balls damage). The described method is based on the shaft displacement signal analysis, which is affected by vibrations coming from the bearings. The diagnostic model’s parameters are determined by processing the signal from the time domain to the frequency domain in a few steps. Firstly, the recorded signal is divided into two observation periods, next the analytical autocorrelation functions are determined and approximated by a polynomial. Then, the diagnostic thresholds are adopted, and the model parameters are converted into damage maps that are easy to interpret and assess the technical condition of the bearings. The presented method shows the technical condition of bearings in a qualitative way. Depending on the received color damage maps, it is possible to determine their level of wear. Green and blue indicate poor wear or no damage, red indicates increased wear, and black clearly indicates a damaged bearing.Keywords
Funding Information
- Ministry of Education and Science in Poland (WZ/WM-IIM/2/2022, PPI/APM/2018/1/00033/U/001, 2017–3475/001–001)
- Polish National Agency for Academic Exchange as part of the Academic International Partnerships (WZ/WM-IIM/2/2022, PPI/APM/2018/1/00033/U/001, 2017–3475/001–001)
- Erasmus+ Programme fund (WZ/WM-IIM/2/2022, PPI/APM/2018/1/00033/U/001, 2017–3475/001–001)
This publication has 82 references indexed in Scilit:
- Roller element bearing fault diagnosis using singular spectrum analysisMechanical Systems and Signal Processing, 2013
- Defect detection in deep groove ball bearing in presence of external vibration using envelope analysis and Duffing oscillatorMeasurement, 2012
- Heat generation modeling of ball bearing based on internal load distributionTribology International, 2012
- Feature extraction for rolling element bearing fault diagnosis utilizing generalized S transform and two-dimensional non-negative matrix factorizationJournal of Sound and Vibration, 2011
- Three-Dimensional Heat Transfer Analysis of Pin-Bushing System With Oscillatory Motion: Theory and ExperimentJournal of Tribology, 2010
- Rotor Blades Condition Monitoring Method Based on the Elimination of the Environment SignalResearch Works of Air Force Institute of Technology, 2009
- Bearing fault diagnosis using FFT of intrinsic mode functions in Hilbert–Huang transformMechanical Systems and Signal Processing, 2007
- A comparative experimental study on the use of acoustic emission and vibration analysis for bearing defect identification and estimation of defect sizeMechanical Systems and Signal Processing, 2006
- DEVELOPMENT OF ENHANCED WIGNER–VILLE DISTRIBUTION FUNCTIONMechanical Systems and Signal Processing, 2001
- A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearingsTribology International, 1999