Exceeding 20.2% Efficiency in Pseudo‐Planar Heterojunction Organic Solar Cells Enabled by High‐Crystallinity L8‐BO‐C 4 ‐Induced Morphology Optimization
Authors:
- 24 April 2026
- journal article
- Published by Wiley in Advanced Functional Materials
- Vol. 36 (47)
Abstract
Optimizing the morphology of the active layer via the incorporation of a sui` third component is crucial for enhancing the device performance of organic solar cells (OSCs). In this study, a third component L8‐BO‐C 4 is introduced into the D18/L8‐BO pseudo‐planar heterojunction (P‐PHJ) system to prepare P‐PHJ OSCs. L8‐BO‐C 4 and L8‐BO share akin chemical structures, but L8‐BO‐C 4 exhibits significantly higher crystallinity compared to L8‐BO, which is achieved through precise control of the branching position of the alkyl chain on the thiophene unit. The high crystallinity of L8‐BO‐C 4 enables it to act as a crystallization inducer during layer‐by‐layer deposition. It not only induces long‐range ordered orientation in the acceptor molecules but also guides the re‐nucleation and recrystallization of the donor layer through interfacial permeation. The optimized molecular packing and continuous interpenetrating network structure effectively promote the generation, transport, and collection of charge carriers. The power conversion efficiency of the P‐PHJ OSCs based on D18/L8‐BO as the main system is increased from 19.06% to 20.24%. This study demonstrates that the judicious introduction of a functional third component is an efficient strategy for further boosting the performance of P‐PHJ OSCs.Keywords
Funding Information
- Natural Science Foundation of Shandong Province (ZR2024QA037)
This publication has 43 references indexed in Scilit:
- A Low‐Cost 3D Spirobifluorene‐Based Acceptor for High‐Performance Ternary Organic Solar CellsAdvanced Functional Materials, 2024
- Sequentially Processed Bulk‐Heterojunction‐Buried Structure for Efficient Organic Solar Cells with 500 nm ThicknessAdvanced Materials, 2024
- Simple‐Structured Acceptor with Highly Interconnected Electron‐Transport Pathway Enables High‐Efficiency Organic Solar CellsAdvanced Materials, 2024
- Halogenation Strategy of Thiophene Derived Solvent Additives Enables Optimized Morphology for Organic Solar Cells with 19.17% EfficiencyAdvanced Functional Materials, 2024
- Over 18.8% Efficiency of Layer‐By‐Layer Organic Photovoltaics Enabled by Ameliorating Exciton Utilization in Acceptor LayerAdvanced Functional Materials, 2024
- Achieving Desired Pseudo‐Planar Heterojunction Organic Solar Cells via Binary‐Dilution StrategyAdvanced Materials, 2023
- Achieving Organic Solar Cells with an Efficiency of 18.80% by Reducing Nonradiative Energy Loss and Tuning Active Layer MorphologyAdvanced Functional Materials, 2023
- High‐Efficiency All‐Small‐Molecule Organic Solar Cells Based on New Molecule Donors with Conjugated Symmetric/Asymmetric Hybrid Cyclopentyl‐Hexyl Side ChainsAdvanced Functional Materials, 2023
- Regulation of Crystallinity and Vertical Phase Separation Enables High‐Efficiency Thick Organic Solar CellsAdvanced Functional Materials, 2022
- Novel Oligomer Enables Green Solvent Processed 17.5% Ternary Organic Solar Cells: Synergistic Energy Loss Reduction and Morphology Fine‐TuningAdvanced Materials, 2022