Experimental Investigation of the Clocking Effect in a 1.5-Stage Axial Turbine—Part II: Unsteady Results and Boundary Layer Behavior
Authors:
- 22 January 2009
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 131 (2) , 021004
Abstract
Comprehensive experimental investigations were conducted to get deeper insight into the physics of stator clocking in turbomachines. Different measurement techniques were used to investigate the influence of varying clocking positions on the highly unsteady flow field in a 1.5-stage axial low-pressure (LP) turbine. A Reynolds number typical for LP turbines as well as a two-dimensional blade design were chosen. Stator 2 was developed as a high-lift profile with a separation bubble on the suction side. This paper presents the results that were obtained by means of unsteady x-wire measurements upstream and downstream of Stator 2 and surface mounted hot-film measurements on the Stator 2 suction side. It was found that for the case when the Stator 1 wakes impinge close to the leading edge of Stator 2 the interaction between the Stator 1 and the rotor vortical structures takes place in proximity of the Stator 2 boundary layer, which leads to a shift of the transition point in the upstream direction. The major loss parameter concerning the Stator 2 aerodynamic performance could be attributed to the strength of the periodic fluctuations within the Stator 2 suction side boundary layer. A phase shift in the quasiwall shear stress signal in the front region of the Stator 2 vane was observed for different clocking positions.Keywords
This publication has 21 references indexed in Scilit:
- Experimental Investigation of the Clocking Effect in a 1.5-Stage Axial Turbine—Part I: Time-Averaged ResultsJournal of Turbomachinery, 2009
- Experimental investigations on steady wake effects in a high-lift turbine cascadeExperiments in Fluids, 2004
- Effect of Unsteady Wake Passing Frequency on Boundary Layer Transition, Experimental Investigation, and Wavelet AnalysisJournal of Fluids Engineering, 2003
- Measurements in Separated and Transitional Boundary Layers Under Low-Pressure Turbine Airfoil ConditionsJournal of Turbomachinery, 2000
- The Effect of Periodic Unsteady Flow on Aerodynamics and Heat Transfer on a Curved SurfaceJournal of Heat Transfer, 1999
- Modeling Unsteady Boundary Layer Transition on a Curved Plate Under Periodic Unsteady Flow Conditions: Aerodynamic and Heat Transfer InvestigationsJournal of Turbomachinery, 1999
- Boundary Layer Development in Axial Compressors and Turbines: Part 3 of 4— LP TurbinesJournal of Turbomachinery, 1997
- Unsteady Boundary-Layer Transition in Flow Periodically Disturbed by WakesJournal of Turbomachinery, 1993
- Experiments on transitional boundary layers with wake-induced unsteadinessJournal of Fluid Mechanics, 1991
- Determination of mean and dynamic skin friction, separation and transition in low-speed flow with a thin-film heated elementJournal of Fluid Mechanics, 1966