Application of Metal Binder Jetting to the manufacture of electric submersible pump stages
Open Access
- 5 July 2026
- journal article
- Published by National University of Science and Technology MISiS in Powder Metallurgy аnd Functional Coatings
- Vol. 20 (2) , 84-95
Abstract
Metal Binder Jetting (MBJ), a layer-by-layer additive manufacturing process that uses metal powders and binding agents, is a relatively new and promising technology. Its principal advantages over other additive manufacturing methods, including selective laser sintering and stereolithography, are its high cost-effectiveness resulting from rapid printing and its compatibility with a wide range of powder materials. The wider adoption of MBJ in industry is limited by insufficient knowledge of this relatively new process. Therefore, investigating the effects of MBJ process parameters on the structure and properties of powder-based materials remains relevant. The study examined samples produced by MBJ from AISI 316L and AISI 304L stainless steel powders. The effect of powder characteristics, layer thickness, and printing and sintering parameters on the structure and physicomechanical properties of the materials were investigated. Samples were printed from powders with particle sizes of 25–45 μm using an Easy MFG 500 Max 3D printer (China). Moisture was then removed in a vacuum drying oven at 100–160 °C, followed by final sintering in a vacuum or a reducing atmosphere at 1350–1400 °C. The study used included particle size analysis, scanning electron microscopy with energy-dispersive X -ray spectroscopy analysis, X -ray computed tomography and standard methods for determining density and strength properties. The Hausner ratio was shown to provide an indirect assessment of the flowability of fine powders. Materials printed from powder with a mean particle size of 25 μm were found to be essentially pore-free, whereas those printed from powder with a mean particle size of 45 μm had a porosity of 6–7 % and physicomechanical properties approximately 10 % lower. Decreasing the layer thickness from 60 to 40 μm while simultaneously reducing the printing speed decreased layerwise porosity and pore size. The proposed MBJ process parameters enabled the manufacture of an ESP impeller and diffuser from AISI 316L steel powder with the specified geometry and dimensions. Their structure and physicomechanical properties were comparable to those of cast steel of the same grade.Keywords
This publication has 20 references indexed in Scilit:
- Review of the types, formation mechanisms, effects, and elimination methods of binder jetting 3D-printing defectsJournal of Materials Research and Technology, 2023
- Prediction model and compensation method for curing shrinkage of inkjet 3D printing partsJournal of Manufacturing Processes, 2023
- Binder jet 3D printing—Process parameters, materials, properties, modeling, and challengesProgress in Materials Science, 2021
- Effect of fine powder particles on quality of binder jetting partsAdditive Manufacturing, 2020
- Understanding powder degradation in metal additive manufacturing to allow the upcycling of recycled powdersJournal of Cleaner Production, 2020
- Design-dependent shrinkage compensation modeling and mechanical property targeting of metal FFFProgress in Additive Manufacturing, 2020
- A review of binder jet process parameters; powder, binder, printing and sintering conditionMetal Powder Report, 2020
- Impacts of process-induced porosity on material properties of copper made by binder jetting additive manufacturingMaterials & Design, 2019
- Binder jetting additive manufacturing with a particle-free metal ink as a binder precursorMaterials & Design, 2018
- Influence of tube wettability on water contact angle of powders determined by capillary riseColloids and Surfaces A: Physicochemical and Engineering Aspects, 2016