High Temperature Corrosion of Titanium Under Conditions Relevant to Pressure Leaching: Mass Loss and Electrochemistry
Authors:
- Jing LiuJLJing Liu
- Akram AlfantaziAkram Alfantazi
- Edouard AsselinEAEdouard Asselin
- 22 September 2014
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 71 (3) , 352-366
Abstract
The corrosion behavior of titanium was studied using mass loss and electrochemical measurements in sulfuric acid with Cl−, Cu2+, and Fe3+ additions up to 175°C. The corrosion rate of titanium in 30 g L−1 H2SO4 + 12 g L−1 Cl− solution at 150°C measured by mass loss was higher than 62 mm y−1. The corrosion rates of titanium under simulated pressure-leaching conditions determined by both mass loss and polarization resistance measurements were consistent, and also suggest that Cu2+ and Fe3+ ions are excellent corrosion inhibitors for titanium. Results from mass loss and electrochemical measurements all confirmed that the corrosion rate of titanium decreased remarkably with the addition of 1 g L−1 Fe3+ to the leaching solution at 150°C, and that the presence of Fe3+ is the most important factor for the growth of titanium oxide films under pressure-leaching conditions. In addition, iso-corrosion diagrams, with 0.1, 0.5, and 1 mm y−1 lines for titanium in H2SO4 solutions from room temperature to 175°C, were constructed from mass loss data.Keywords
This publication has 54 references indexed in Scilit:
- The temperature dependence of passivity breakdown on a titanium alloy determined by cyclic noise thermammetryElectrochimica Acta, 2010
- Corrosion of Ti-2 and Ti-7 relevant to nickel acid leach chemistryHydrometallurgy, 2010
- Nucleation of corrosion pits in Ringer’s solution containing bovine serumCorrosion Science, 2007
- Corrosion of Titanium and Its Alloys in Sulfuric Acid in the Presence of ChloridesJournal of the Electrochemical Society, 2006
- The effect of temperature on the nucleation of corrosion pits on titanium in Ringer's physiological solutionBiomaterials, 2005
- Temperature Dependence of Crevice Corrosion Initiation on Titanium Grade-2Journal of the Electrochemical Society, 2002
- Corrosion behaviour of titanium in biofluids containing H2O2 studied by electrochemical impedance spectroscopyCorrosion Science, 2001
- Hydrogen Absorption and the Lifetime Performance of Titanium Nuclear Waste ContainersCorrosion Reviews, 2000
- Anodic Dissolution and Passivation of Titanium in Acidic Media: III . Chloride SolutionsJournal of the Electrochemical Society, 1979
- Anodic Dissolution of Titanium in Acidic Sulfate Solutions: II . Effects of Ti(III) and Ti(IV) IonsJournal of the Electrochemical Society, 1976