An overview on the recent advances in computational fluid dynamics simulation of spouted beds
Authors:
- 13 September 2013
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 91 (11) , 1822-1836
Abstract
Spouted beds are now widely applied in various physical operations and chemical reaction systems due to their unique structural and flow characteristics. Now there are growing interests to use computational fluid dynamics (CFD) to understand dense gas–solid two‐phase flows in spouted beds. Both Eulerian–Eulerian (two‐fluid model, TFM) and Eulerian–Lagrangian (discrete element method, DEM) approaches can be applied to the CFD modelling of spouted beds and spouted‐fluidised beds, and numerous verification studies have shown their reliabilities. This overview summarises the recent advances of the TFM and DEM approaches in the CFD modelling of spouted beds. The typical flow patterns of spouted beds can be well reproduced by both the TFM and the DEM approaches, and the simulated characteristic properties such as spout diameter, minimum spouting velocity and voidage profile are in good agreement with experimental data, indicating that CFD modelling based on the TFM and DEM approaches can serve as an important tool for predicting gas and solids behaviour in spouted beds. The TFM approach has been widely used in phenomenological studies that are mainly towards the understanding of the flow behaviour of the whole system. Although more computational capacity is required, the DEM approach offers a more natural way to simulate gas–solid flows, with each individual particle tracked in the simulation and can be applied readily for particle tracking, collision, mixing, circulation and mass transfer studies that are aimed at obtaining the profound particle‐scale understanding in fluid–solid multiple‐phase systems. However, each approach has its own limitations and defects. The complex nature of the TFM‐based simulation framework requires both proper descriptions of pseudo‐fluid properties like solid pressure, solid viscosity, solid friction stresses, etc. and suitable choice of drag models, and the boundary conditions also have effects on the simulation results. Moreover, the effects of these factors often interact with each other, which require even more subtle skills in conducting a simulation. In the DEM approach, the high computing source requirement limits its application of no more than several million particles. Furthermore, more insight investigation should be given to the acting mechanism of several forces on particles. One common challenge for these two approaches is to properly describe the inherent turbulence for both the solid and gas phases, especially for the spout region. Further fundamental and experimental studies on the kinematic properties of the two phases are needed to improve the accuracy of the CFD models.Keywords
This publication has 97 references indexed in Scilit:
- DEM simulation on particle mixing in dry and wet particles spouted bedPowder Technology, 2011
- Recycling poly-(methyl methacrylate) by pyrolysis in a conical spouted bed reactorChemical Engineering and Processing - Process Intensification, 2010
- Effect of multiple impacts on high velocity pressed iron powderPowder Technology, 2009
- Numerical simulation and experimental study of fluid–particle flows in a spouted bedPowder Technology, 2009
- DEM simulation of the particle dynamics in two-dimensional spouted bedsPowder Technology, 2008
- Discrete element method simulation of three-dimensional conical-base spouted bedsPowder Technology, 2008
- DEM simulation of the mixing equilibrium in fluidized beds of two solids differing in densityPowder Technology, 2008
- CFD modeling of the gas–particle flow behavior in spouted bedsPowder Technology, 2008
- Hydrodynamics of a spouted bed with a porous draft tube containing a small amount of finer particlesPowder Technology, 2003
- Numerical simulation of two-dimensional fluidized beds using the discrete element method (comparison between the two- and three-dimensional models)Powder Technology, 1998